|
- A Dashboard App for Android Windows - Link Engine Management
It will also work on old G4 Vipec V series ECU's Connection to your tablet smartphone is direct using your normal Link USB tuning cable, for phones tablets that only have a micro USB port you will need a "Micro USB OTG adapter" Instructions for setup and connection attached to bottom of this post
- PC Link and Firmware 6. 20 released - Link Engine Management
2) ECU に記録せずにイグニッションをオフにします。 (3) ECUを完全に遮断した後、再度イグニッションをONにしてもLINK ECUが起動しません。
- G4x - Forums | Link Engine Management
Discuss Link G4x engine management questions, share knowledge, and connect with other enthusiasts in this dedicated forum
- Link EVOX Solution! - G4x - Forums | Link Engine Management
After lots of questions from people all over the world, I have finally decided to come up with a solution that will allow a Link ECU into late model cars that we have reverse engineered I have developed a CAN Gateway device that handles all bi-directional communication between aftermarket ECU's and factory OEM systems
- Issues with PC Link USB drivers install
Hello all, I am having issues installing the USB drivers for the G4X G5 Software (I bought a G4X Altezza Link ECU) I installed it on my home PC and everything worked fine, it's detecting the ecu and all, but I can't really use it on there as I have to be in the car So I grabbed myself the old N
- E-Throttle Module - G4+ - Forums | Link Engine Management
I currently run a Link Storm G4+ and am looking to convert to DBW Throttle Is there any downside to running this E-Throttle module versus upgrading the ECU to one that has built in DBW (G4X Extreme)?
- Link ECU CAN Custom configuration
I have multiple Link ECUs, and each one is connected to CANchecked and RealDash I'm trying to learn more about the CAN bus and how to create custom CAN streams I’ve started with the basics and so far, I understand that each CAN stream consists of several CAN frames (for example, the Generic Das
- link pressure sensors - G4+ - Forums | Link Engine Management
I check at the ecu pin , I use AN volt 4 and 5 for my pressure sensors , I have approx 0,2 volts at the pin but PC link show me zero , even when the fuel pump is on , i didn't start the engine yet just left the ignition on , I prefer test all my sensor before cranck the engine
|
|
|