|
- How to patch fstools? - For Developers - OpenWrt Forum
I wish to patch fstools I saw there's a mirror on github Is it possible to use a local clone of that when building custom OpenWrt images? How? Thanks
- 24. 10. 0 update error : impossible package selection
Heres the packages , these my usual packages i copy and paste in past releases from rc2-rc5 base-files ca-bundle dnsmasq dropbear firewall4 fitblk fstools kmod-crypto-hw-safexcel kmod-gpio-button-hotplug kmod-leds-gpio kmod-nft-offload kmod-phy-aquantia libc libgcc libustream-mbedtls logd mtd netifd nftables odhcp6c odhcpd-ipv6only opkg ppp ppp-mod-pppoe procd-ujail uboot-envtools uci uclient
- Patch fstools to set the overlay partition via a kernel parameter
i can set the rootfs partition via the kernel parameter root= dev mmcblk0p<n> is there a similar way to set the rootfs_data partition?
- How to open a WEP AP correctly? - OpenWrt Forum
I'm on the latest snapshot (r26302-4f87a4d84f ) on Generic x86 64 Builded with the firmware selector with this config: base-files busybox ca-bundle dnsmasq dropbear e2fsprogs firewall4 fstools grub2-bios-setup kmod-amd-xgbe kmod-bnx2 kmod-button-hotplug kmod-dwmac-intel kmod-forcedeth kmod-fs-vfat kmod-igb kmod-igc kmod-ixgbe kmod-nft-offload kmod-tg3 libc libgcc libustream-mbedtls logd luci
- Building Image with openssl - OpenWrt Forum
Hi there, i'm finally coming around to update to 23 05 and just want to make sure to not F* up something 😉 I want to keep TLS1 3 and thus openSSL Of course, the image build fails if i just include libustream-openssl It build successfully if i also exclude libustream-mbedtls with -libustream-mbedtls But in config, there are a lot of defaults for mbedtls - is that an issue that needs to
- Problems with getting custom build snapshot for Raspberry PI 5 . . .
Hello, everyone! I am new one here, so please don't harshly criticize me, if my post in some way breaks the rules of topics start For several days in the row I try to get custom build from snapshot for Raspberry PI 5 with following set of required packages: base-files bcm27xx-gpu-fw bcm27xx-utils block-mount blockd brcmfmac-nvram-43455-sdio busybox ca-bundle collectd collectd-mod-ethstat
- Need advice for an warning message with 24. 10. 0-rc4 factory rom
Hi With new custom rom build with 24-rc4, I have got the warning message when I try to upload the image into device What does the warning message mean? Am I did something wrong or Just ignore the message and do 'force upgrade' is fine? (I'm scaring that being the device brick ) The target device is Linksys WRT32X
- Custom x86_64 hardware with N4100 and I226-V - OpenWrt Forum
Hello folks, First time using the forum of OpenWrt, please disregard if I do anything wrong or ask any silly questions So I'm about to receive a custom mini-PC with the following hardware specification: CPU: Intel N4100 RAM: 8GB NIC: Intel I226-V (4 ports) Features: AES-NI, x86-64, VT-d Then I used Gemini Advance to optimize the packages list in Firmware Selector (FS) of OpenWrt (OW) so that
|
|
|