|
- Unable to perform application-aware processing because connection to . . .
The error itself is not expected, and we will need you to open a Support Case and allow Veeam Support to review the job
- Veeam - Unable to perform application-aware - Data Storage, Backup . . .
If you cannot connect to it by IP either, if they are on separate VLANS, check that any firewall between them, allows RPC connections, do a firewall trace if you’re not sure what is needed, ensure the local firewall on the guest is also not the cause
- Unable to perform application-aware processing error on Veeam
Briefly, I recommend the following steps to solve these kind of problems On VBR Console, right-click the failed job and click on the Edit Then click on Guest Processing on the left section, and then click on the Test Now button to start checking the credentials that you set for this job
- Server Error: Unable to perform application-aware processing
Veeam Community discussions and solutions for: Server Error: Unable to perform application-aware processing of Microsoft Hyper-V
- Unable to perform application aware processing veeam Backup
To create transactionally consistent backups or replicas of VMs that run Microsoft Active Directory, Microsoft SQL Server, Microsoft SharePoint, Microsoft Exchange or Oracle, you must enable application-aware
- Troubleshooting Veeam Application-Aware Backups
This warning message occurs when Veeam tries to perform application aware processing or guest indexing, but it cannot communicate with the Guest OS of the VM being backed up
- Unable to perform application-aware processing on Exchange 2019
The Domain Controllers have application aware processing enabled and the processing appears to work as expected successfully The Exchange server however runs the backup but finishes with warnings and does not perform application aware processing so Exchange logs do not get truncated
- Unable to perform application-aware processing because . . . - Veeam
Alternativ kann auch die Verbindung mit Powershell Direct über den Hyper-V Host aufgebaut werden Dafür ist ein Hyper-V Administrator notwendig Im Backup Job selbst unter Guest Processing, gibt es einen Test Da könntest du prüfen an was es scheitert, bzw wie die anderen VMs verarbeitet werden
|
|
|