|
- How to open a Raspberry Pi Linux port?
To open or close ports I simply use sudo firewall-config This program is a GUI for iptables and quite easy to configure: You can open a port either by knowing the corresponding name (http, ssh, samba, smtp, ) or by entering the port number itself It's only a few clicks and the port is opened or closed
- Permission denied using Serial - Raspberry Pi Stack Exchange
I'm using some XBee to build a mesh network and everything is working, BUT only if I run the code using sudo Now that the code is "Finished" i want to remove this need, because i know that it isn't
- Open Port 1433 on Raspberry Pi
It cannot tell you if some remote server you are not connected to has a specific port accessible to you, because that is not what ss is for It is what nmap and arp are for though If you know the IP address of the server, you can check if TCP port 1433 is open there with: nmap -sT -p1433 x x x x Where x x x x is the IP address
- Rpi Python Serial Test Program - Raspberry Pi Stack Exchange
# Test 2 - loopBackTest() - UART port send and receive bytes # Function - Send one bytes to TX, wait some time (Note 1), then read bytes back from RX # Setup - Connet Tx pin to Rx pin to form a loop
- Raspberry Pi 3 Raspbian open port or make my webapp accessible from LAN
I installed nodejs on it and started node server on port 3000 I can open it from Raspberry Pi but I can't open it from local network All I need is to run a web app on my RPI and make it accessible from local network This is how I can open it on Raspberry: This is what I see if I try to open it from other computer in the network:
- How to open port without setting router in Raspberry Pi 3 B+? Port 25565
For this is the port number The ssh server has default port 22, the web server has default port 80 and the Minecraft server has default port 25565 If you want to connect to it then you have to connect to 192 168 10 11:25565 This means a running Minecraft server has always its port open, otherwise you won't be able to connect to it
- Edit iptables to open a port the safest and easiest way (nano?)
The command to open the port I already tried was: sudo iptables -A INPUT -p tcp --dport 8092 -j ACCEPT and it didn't open the port I also was told to run this command to open the port which maybe could help: iptables -t nat -A PREROUTING -i lo -p tcp -d 127 0 0 1 --dport 8092 -j DNAT --to-destination 192 168 1 202:8092
- Remote access using reverse ssh tunnel, without port forwarding
You MUST have an open port to connect to something Anything else is like talking to someone's locked front-door instead of that person Reverse tunnelling: This means that the Pi3 connects to something Then orders that something to return traffic through that same connection This way you can talk to your Pi3 through that tunnel
|
|
|