|
- r OrcaSlicer - Reddit
r OrcaSlicer: Unofficial space for Orca Slicer users to discuss settings, features and tips
- Does the cost estimator in orca not work? : r BambuLab - Reddit
ANSWER: I was having the same issue I was a little stumped at first, but after looking at the settings between Orca and Bambu, I noticed there was a "Time Cost" setting in the PRINTER SETUP section in Orca but not Bambu When I set up the printer profile, I had put a value of $10 hr in there
- How do I fill these gaps? : r OrcaSlicer - Reddit
1 8K subscribers in the OrcaSlicer community Unofficial space for Orca Slicer users to discuss settings, features and tips
- First layer settings in Orca Slicer? : r OrcaSlicer - Reddit
I'm new to Orca Slicer (have been using Cura mostly for years) I'm trying to switch over, but it's a learning curve Recently, I have been wanting to close some gaps on a first layer with an inset design, and so I went looking for the first layer settings in Orca Slicer 1 6 6 (but have not found them) I have the "advanced" switch on, and have checked under the tabs for quality, speed, other
- Is orca slicer any good : r 3Dprinting - Reddit
Orca is based on Bambu which is based on Prusa which is based on something else that is probably based on something else Orca and Cura have different user interfaces and preference is a personal thing They also have different slicing engines so they produce different tool paths
- Whats peoples opinion on Orca vs Prusa slicer? : r 3Dprinting
Orca slicer is a fork of bambu slicer which is a fork of prusaslicer from what I have read I have only used prusaslicer but judging by screenshots they're similar
- How do I add text to a model that is flush? : r BambuLab - Reddit
Orca Slicer's text mode is well, not necessarily your friend, but a reasonable way to do this Then use the "fill" mode in the paint tool
- Delete System Presets : r OrcaSlicer - Reddit
trueUnofficial space for Orca Slicer users to discuss settings, features and tips
|
|
|