|
- Ford Fusion Stalling → Causes Diagnosis | Drivetrain Resource
One of the most common issues your Ford Fusion is likely to develop is a stalling problem The most challenging part of diagnosing a stalling problem is reproducing the conditions that led to the stall in the first place
- 2012 Fusion randomly stalls when stopping - Ford Forums
Starting two months ago, the engine will randomly shut off when coming to a stop Put it in park, crank it up and it goes like nothing happened No warning, no lights, no shuddering, no codes It might do it a couple times a week and then nothing the next week
- Almost Stalls out after accelerating and stopping. - 2. 3L 2 . . .
2012 Fusion SE 2 5L Auto 112k miles Noticed something odd this morning On my drive into work this morning I accelerated from a light and the car in front of me stopped, so I did the same When I stopped the idle dropped down to around 450 or so (almost stalling) and then came back up and hunte
- 2012 Ford Fusion - Stalls - Maintenance Repairs - Car Talk . . .
There’s many things that could cause a stall Since there’s some check engine light involvement apparently, there will be engine diagnostic codes stored in the computer’s memory
- 2012 ford fusion se 2. 5 liter has stalling at stop . . . - Fixya
This sounds like a vacuum leak, try spraying starting fluid or carb cleaner around the intake manifold and if it speeds up you found the leak if you can't find it take it to a shop that has a smoke machine to locate leaks I hope this helps Take Care
- My fusion randomly stalls out when starting. Any ideas? *more . . .
I finally discovered the actual problem when the car wouldn’t start and I received an error SHIFT SYS FAULT The car would start, just not shift and that ended up being the plastic washer that connects the Transmission shift cable to the top of the transmission under the hood
- 2012 Fusion Stalling at Low RPMs? Expert Troubleshooting Guide
If the engine stalls when coming to a stop, this could be due to an issue with the transmission or torque converter Another likely cause could be an air or vacuum leak, or a faulty mass airflow sensor
|
|
|