|
- rs232 - What is the difference between RS-232 and RS-232-C . . .
The formal standard that later became mainstream was EIA 232 C, where EIA is the standard institute and C is revision This one is sloppily referred to as RS-232-C, since RS-232 is such a well-known name
- serial - Electrical Engineering Stack Exchange
In RS232 serial communication as pictured below how does one ensure the bit stream is always read at the start stop bits? I’m looking at this waveform and considering a case where two consecutive
- serial - Difference between UART and RS-232? - Electrical Engineering . . .
Most of the time RS-232 and UART come together in serial communication theories Are they both the same? From my readings I concluded UART is a hardware form of the RS-232 protocol Am I correct?
- communication - RS232 for PCB Design and Connectors - Electrical . . .
From the info doc for PCB 1, the RS232 lines are a serial debug port with a bit rate of 250 kbps with voltage levels accurate to EIA TIA-232 and an optional mounting variant to 3V3-TTL
- serial - Electrical Engineering Stack Exchange
What each RS-232 communication wire does is a vast subject and covered in many articles about RS-232 communications elsewhere How to debug RS-232 interface with a LED tester tool is also a vast subject requiring in-depth knowledge how RS-232 signals work and how your specific devices happen to use them
- How do I know if its RS232 levels or TTL levels
From the parts (complementary BJT transistors and discretes near the connector) I think it's a non-standard RS-232 port that idles at 0V rather than -9 or whatever
- Serial, RS232, Modbus, UART and TCP
I want clearly know this, Serial is protocol right? Then what is the Modbus? Is it under serial And what are RS232 and RS485? What is UART and serial and UART same? What about TCP? TCP and seria
- How to tell what serial protocol is used on a DB9 connector?
The RS-232 DB9 is well standardized You'll have Rx on pin 2, Tx on pin 3 and GND on pin 5 Optional handshaking signals on the rest of the pins This assumes that the device is a terminal at the end of the bus Otherwise Tx Rx may switch places in case the device is to be regarded as a "modem", a middle man between terminals As seen on for example Wikipedia, RS-232 logic levels are 3V to 15V
|
|
|