|
- New Updated Rim Tire Fitment For S Trucks - S-10 Forum
THE CHART IS FOR S10S SONOMA BLAZERS 2WD ONLY HERE Well, this chart should work and help you guys out 6 7 drop and bags here we go THIS CHART IS FOR THOSE WHO USE SPINDLES AND SPRINGS THE SPINDLES MOVE THE FRONT TIRE OUT 1 2 INCH S10 SONOMA PRE 97 BLAZER AND JIMMY 2WD 3-inch drop in front stock s10 rims 15x7 245 60 15 15x7 4 BS 235 60 15
- LSx Conversion Information - S-10 Forum
This post is a compilation of parts, suggestions, tips, and practices to successfully swap an LS-based engine into an S10 Truck (2WD and Blazer variants) Most swappers generally underestimate the total costs and time for these conversions Keep the engine bay clean Once the original engine is
- Rear end gear ratios - S-10 Forum
My truck is an 01 2 2L 2wd Just wondering if I need to lookout for different ratios or if they were all the same in the 96-01's and if the 4 3 had different ratio?
- 2WD Wrangler? | Jeep Wrangler Forum
To verify if a Wrangler is 2WD or 4WD, check for a front driveshaft going to the front differential Also, 2WD Wranglers are sometimes used by rental companies because they are cheaper and renters are contractually prohibited from off-roading Jeep Wrangler Forum provides answers from our community and over 22 other related forums
- End-all answer to S10 axle widths? - S-10 Forum
I've searched many forums over the past couple of hours and have found nothing definitive I'm trying to find accurate measurements of S10 axles, not "I think it's about xx inches wide " I need to know 2WD, 4WD and ZR2 widths from WMS to WMS A guy has an 8 5 (or 8 625) with G80 from his ZR2
- Riptides 2WD Conversion Writeup - Jeep Wrangler Forum
This thread documents a 2WD Jeep Wrangler (JK) to 4WD conversion Key steps include sourcing a Dana 30 front axle (matching gear ratio to the rear), front and rear driveshafts, a transfer case (2007-2011 models are recommended for compatibility), a 4WD shifter and cable, and a 4WD adapter Parts can be found on Craigslist or from Jeep dismantlers
- Big Brake Parts or Kits for S10 needed - S-10 Forum
2wd '98+ blazer spindles hubs, Kore3 adapters and lines, C5 calipers and 13" rotors - All 'off the shelf' parts that bolt together and work well I ran Carbotech AX6 pads on that setup and they felt like they could stop a train on R-compound tires I probably had ~$800 USD into the setup including rebuild kits and paint for the calipers
- Backspacing and offset UPDATE! - S-10 Forum
This is the style wheel a 2wd S10 requires for a stock fitment Lastly is the Negative offset: This style rim has the mounting flange shifted towards the back side of the edge towards the brakes This wheel has a small backspacing, and so on; a 2wd S10 will push the wheels out of the wheel well further
|
|
|