|
- OFFICIAL 2020 Marantz SR8015 Owners Thread - AVS Forum
The new Marantz SR8015 is the first 11CH AVR from Marantz capable of 13CH processing when using an external 2CH amp It will have a 3 year life cycle so will continue to be discussed in this thread until it is replaced in 2023 MSRP - $3199USD (only available in black in the USA CA), avail
- 11. 2 Channel THX Certified AV Receiver Review - AVS Forum
Whereas the 8015 and RZ70 are both 11 ch avr's and can power all 11 ch without the need for any separate amps The 8015 is the only of the 3 that will power a 9 2 2 setup Also you can hookup 13 speakers to the 8015, for example a set of front wides But it will only process 11 at one time
- Marantz pre amp mode? - AVS Forum
I have a question about the new pre amp mode on the new line of Marantz receivers I have heard that the upper end models like the SR 8015 tend to run a bit hot I use an external power amp to power my front speakers Now that the pre amp mode disconnects the power amp section of the receiver
- Needing to upgrade my ancient Denon AVR: So should I go. . .
The 8015 has some advantages, i e 140w channel, beefier power supply, sounds better with 2 channel (so I’ve been told), but it will not get DIRAC I think I’m actually going to return my Cinema 50 to get the Cinema 40, because that was my original plan, but it wasn‘t available at the time
- Denon 6700H vs Marantz SR-8015 - AVS Forum
I am planning to upgrade my current receiver (Denon 3600H) to support 7 1 6 Atmos setup I was looking at Denon 6700H so far and then randomly came across the SR8015 model as well Indeed it was on sale few months ago and even cheaper than the 6700 Made me curious which model should I go with
- A1Evo MJ Custom | Page 33 | AVS Forum
Intro Link This is a custom version of the original A1Evo I created for my personal use I have been getting excellent results with it and wanted to share it on the forum The custom version is based on the last released version of the 1-Click A1Evo Maestro MJ solution It works with both
- Trying to Play Tidal Dolby Atmos Stream on Marantz 8015
Starting to think it is impossible to play a Dolby Atmos stream through my Marantz 8015 First I tried using my Bluesound Node 2i, it doesn't do this through the optical or stereo outputs Second, I tried using my Xbox Series X console, surprise, no Tidal app for it Third I used the Marantz
- 4 or 8 ohm receiver setting? - AVS Forum
BACKGROUND: I have this receiver (8015), if you don't play it loud you have little to worry about, if you play it loud, glance at the fan's digital display to make sure it's not getting close to 100 degrees and you will be fine, I bought 5 Arendall 4 ohm speakers, mains, center and surrounds (5 4 ohm speakers powered out of 11 total speakers
|
|
|