|
- adafruit industries - Forums Index
ADAFRUIT CUSTOMER SUPPORT FORUMS Thanks for stopping by! These forums are for Adafruit customers who need assistance with their purchases from Adafruit Industries We also assist customers who purchased Adafruit products through one of our official Distributors Please select a Category below and continue on to the next page to Post a Topic
- ICM20948 Calibration and Heading Output - adafruit industries
Moderators: adafruit_support_bill, adafruit Please be positive and constructive with your questions and comments
- Misunderstanding OLED i2C SCREEN_ADDRESS value - adafruit industries
by adafruit_support_carter » Mon Nov 25, 2024 10:56 am There's nothing special about the I2C address relative to OLED screen size The comment is probably specific to the default addresses used for those on Adafruit OLED products But it can vary, and can potentially be set to something alternate by the user
- multiple NEOPIXEL strips - adafruit industries
I am trying to use three identical neopixel strips (adafruit 2969) to perform the same sequence I have declared three unique calls to Adafruit_NeoPixel strip and pixel
- adafruit-mpr121-Capacitive Touch Sensor-proximity detection
Re: adafruit-mpr121-Capacitive Touch Sensor-proximity detection by adafruit_support_bill » Mon Mar 03, 2025 1:50 pm It is all a matter of changes in capacitance and the difference between touch and proximity is mostly a matter of degree If the thresholds are set for maximum sensitivity, it can detect without actual contact
- MAX31855 Calibration - adafruit industries
MAX31855 Calibration Moderators: adafruit_support_bill, adafruit Please be positive and constructive with your questions and comments
- ESP32-S3 hangs on Hard resetting via RTS pin. . . - Adafruit Industries
adafruit_support_carter wrote: Tue Nov 01, 2022 12:46 pm At the point you see the "Hard resetting via RTS pin" message, you need to manually press the reset button on the Qt PY for the board to reset and run the loaded sketch
- ImportError: No module named Adafruit_DHT
adafruit_support_carter wrote: On your system, "python" is mapping to Python 2 while "pip" is mapping to Python 3 If you installed using "pip" and then ran using "python", then the library was installed for 3 but you are running 2
|
|
|