- verilog - What does always block @ (*) means? - Stack Overflow
The (*) means "build the sensitivity list for me" For example, if you had a statement a = b + c; then you'd want a to change every time either b or c changes In other words, a is "sensitive" to b c So to set this up: always @( b or c ) begin a = b + c; end But imagine you had a large always block that was sensitive to loads of signals Writing the sensitivity list would take ages In fact
- verilog - Use of forever and always statements - Stack Overflow
The difference between forever and always is that always can exist as a "module item", which is the name that the Verilog spec gives to constructs that may be written directly within a module, not contained within some other construct initial is also a module item always blocks are repeated, whereas initial blocks are run once at the start of
- Always vs forever in Verilog HDL - Stack Overflow
The always construct can be used at the module level to create a procedural block that is always triggered Typically it is followed by an event control, e g , you might write, within a module, something like: always @(posedge clk) <do stuff> always @(en or d) <do stuff> always @* <do stuff>, can also use @(*) This is the typical way to write latches, flops, etc The forever construct, in
- How do I run Visual Studio as an administrator by default?
I recently discovered that even while logged into my personal laptop as an administrator, Visual Studio does not run in administrator mode and you need to explicitly use Run As Administrator Is t
- tfs - How to stop Visual Studio from always checking out solution . . .
How to stop Visual Studio from "always" checking out solution files? Asked 16 years ago Modified 2 years, 4 months ago Viewed 70k times
- mcp server always get initialization error - Stack Overflow
I create a mcp server by FastMCP, I can ensure that the mcp server has already finished the initialization, due to the server has already process several tool request, but I also get following error:
- How to code a BAT file to always run as admin mode?
I have this line inside my BAT file: "Example1Server exe" I would like to execute this in Administrator mode How to modify the bat code to run this as admin? Is this correct? Do I need to put the
- Difference among always_ff, always_comb, always_latch and always
I am totally confused among these 4 terms: always_ff, always_comb, always_latch and always How and for what purpose can these be used?
|