|
- Cheely 2011 Thumb Safety - Brian Enoss Forums
What ambi safeties have you had good luck with Cheely frame and grip? I don’t think I want to go with a shielded safety With the popularity of the machined safeties (EGW, EB, Wilson) with a special hammer pin, hoping to get some first hand experience with fit and finish, and it one is preferred
- Gen5: Cutting off the right side of the slide lock release
Cutting off the right side slide release from the ambi part eliminates that friction, which is most prevalent at the "wall" of the trigger pull You can actually see the right side of the frame push out a little as the trigger pull completes and the trigger bar rubs against the ambi release
- Sig P211 - Initial Thoughts on Fit, Finish Functionality
The ambi mag release works just like the P320 one when taking in apart A reviewer I saw said the P22 uses the same mag release as the P320 but that is not totally correct I think only the P320 AXG release is the same since it has the same circular profile My P320 and others I have seen has a triangular mag catch profile
- 2011 shielded thumb safety recommendation - Brian Enoss Forums
My recent experience with a Wilson was disappointing One cracked before I completed installation, the replacement was so spongy that pushing the right hand side wouldn't completely disengage the left side These weren't the shielded ones mind you, but these ambi ones were just MIM'd
- How to install ambi safety on an AR-15 - Brian Enoss Forums
All, Can someone please post step by step instructions on how to replace a single sided safety with an ambi safety on an AR-15 I did look on AR-15 and have a basic concept, but they show you the process on a stripped lower I need to do this on a completed rifle Please feel free to dumb this do
- Springfield Pinch-o-Matic (Prodigy) - Brian Enoss Forums
Flipping the ambi safety to off will pinch the palm of my left hand I don’t have this issue with my 1911’s but the 1911’s don’t have the fat grip of the Prodigy
- EGW ambi thumb safety removal - Brian Enoss Forums
EGW's Ambi safety is one of the ones where the right safety is retained by a custom hammer pin You cannot remove the right safety without first removing the left Chris, try wiggling the safety in and out perpendicular to the frame The safety wants to come straight out If you are just pulling outward on the paddle, you'll have a tough time
- My Prodigy 5 Build - 1911-style Pistols - Brian Enoss Forums
My 5” Prodigy has run 100% except for an old batch of reloads from last year They run through my Glocks fine but there isn’t quite enough crimp on them to make the Prodigy happy There is an oocassional FTF with these loads Everything else runs like a champ The chamber is a little tighter than my Glocks Mods: Dawson guide rod Wilson High wide ambi thumb safety EGW ignition kit Wilson
|
|
|