|
- Does anyone know why my bind receiver option isnt showing in . . . - Reddit
Does anyone know why my bind receiver option isn't showing in Betaflight? Question? I just got a Flywoo Baby Nano 20 and plugged it in to BF Config I did a CLI dump for the back up and when I went to bind the receiver, the bind receiver button just isn't there It doesn't exist It's an ELRS UART receiver
- Transmitter bound but not showing in betaflight : r fpv - Reddit
If no - create Check configuration in Betaflight: a) Port configuration, b) Main configuration tab about Receiver Go to the Receiver tab and play with Throttle, for example Even if it not configured the right way you will see that Roll Pitch Yaw is moving Just change the Channel map If you have another build - try to swap hardware
- Very very very handy pid tuning cheet sheet I stole somewhere - Reddit
Honestly wish I had patience to pid tune But the presets out there in the latest betaflight fly far better than anything I'll tune
- How do you determine the ELRS version of your radio and receiver . . .
I've tried the CLI command, the button on Betaflight receiver tab, and manual 3x power method I'm reading that for ELRS, the radio and receiver have to be on the same version, so how do I determine this for each device? There's a 3 3 0 at the bottom of the ELRS LUA script on the radio--is this the version for the radio?
- Guide: Cetus X (BetaFlight FC Version) - Reddit
Guide: Cetus X (BetaFlight FC Version) - Unable to BIND Bad Firmware Update Lost Configuration Erased Stock Settings I decided to write this up after have this happen myself, and found it somewhat difficult to find the solution
- betaflight - Reddit
r betaflight: Betaflight is a flight controller software (firmware) used to fly multi-rotor, fixed wing craft and much more! Feel free to ask…
- Failed To open Serial Port- Betaflight : r fpv - Reddit
Ive tried connecting to fully updated windows 10 with and without betaflight recommended drivers, Ive followed all steps on JB videos, and ive tried changing cables, Operating systems and so on
- Unable to update SPRacing F3 V1? : r Multicopter - Reddit
Flashing such an old board, i'd guess you would need to use an older version of the Betaflight Configurator aswell My F3 is recognized by Configurator version 10 6 0
|
|
|