|
- Boating Forum - iboats Boating Forums
Discussion of boats, general boating questions and anything else directly related to a boat or an engine
- What horsepower motor to use on light weight 14 aluminum boat?
I was wondering what size outboard motor to use on my 14' harbercraft aluminum boat? The boat is pretty light, probably 165lb-180lb range and I bought it off a guy who used to put on top of his canopy on his truck My boat has a 15" transom and like I said it is pretty light weight and probably comparable to a 14' starcraft
- Boat crash Parker- Idiot rock | River Daves Place
A boat full of people ran into idiot rock last night across from echo Anyone have any info on the passengers? @NicPaus are you at your place? I’ve been hoping all night they found everyone, we stayed away from the lights and just kept an eye out down river a bit🫤 I think he mentioned he would be out at Echo this weekend
- HOW to remove old gas from internal gas tank - iboats Boating Forums
Re: HOW to remove old gas from internal gas tank the boat is out of the water and time get going on this project bummer- of course, the sending unit is someplace that is not easily accessible would hate to take off the helm so that being said, can i pull the fuel from the line that leaves the tank and hits the water fuel sep??
- Lets Talk Boat Prices - 2025 | River Daves Place
Like the title says, let's talk about boat prices A couple comments in the Hallett 255 thread said, "Covid prices are coming down finally" and "2020 - 2024 is over" Are the prices really coming down?? And of course 2020 - 2024 is over, it is 2025 😉😉 But seriously though, I don't see any
- How to check fuel tank vent anti syphon valve
The anti-siphon valve is very similar to a simple check valve Its purpose is to prevent fuel from starting a siphon out of the tank and into the carb engine compartment This could cause a fire or continue to feed a fire by dumping fuel when the engine is off It is especially a concern on larger boats where the fuel tank may be mounted higher than the fuel inlet to the carburetor, which
- Troubleshooting Trim Gauge Sender - iboats Boating Forums
hi everyone I installed a new trim sending unit and limit switch this weekend with new wiring through the transom housing and hooked everything up I turned the key to the “On” position, and the trim gauge just stays pegged all the way up It stays that way whether key is on or off with no
- Do I need 4x4 to launch boat? - iboats Boating Forums
Re: Do I need 4x4 to lauanch boat? Re: Do I need 4x4 to lauanch boat? If you get a locking rear end and are careful a 2wd will handle "most" ramp situations I have seen some 2wd owners carry a set of traction mats just in case It really depends on the ramp, how deep you need to launch and the surface conditions I know of some ramps that a 2wd is fine and some where a 4wd is required I have
|
|
|