|
- Do I need 4x4 to launch boat? - iboats Boating Forums
Re: Do I need 4x4 to lauanch boat? Speaking from experience with both, a dually is completely worthless when traction is low I got my dad's crew cab powerstroke stuck in my VERY slightly inclined yard, on wet grass, trying to pull an EMPTY 18' flatbed trailer the truck had to sit until the grass dried up
- Boating Forum - iboats Boating Forums
Boat Trailer Tie Downs Couplers, Mounts, Hitches, Locks SeaSense Trailer Winch Shop Trailer Winches
- Homemade bunk slicks | Boating Forum - iboats Boating Forums
My boat weighs in at about 900 lbs and I've had no issues at all My bunks cross several rows of rivets which hold ribs in place I replaced a set of bunk roller strips on which all the rollers were split in favor of the HDPE strips taken from a custom counter top at where I used to work
- How to position guide-ons? - iboats Boating Forums
I checked the WIDEST part of the boat and set the guides , the thickness of my hand (layed flat against the boat) which is maybe 11 2" wider I also put self centering rollers for the keel took the axle out of the guide rollers and put never sees (sp) on the then reasembled them
- Water logged foam. . . best way to dry out - Boating Forum
the boat hull cracked above both wheels, where the bottom meets the sides, about a foot long on both sides He did an OK repair job, which began to fail right after i purchased it, this began letting water in the middle section
- Whats new | Boating Forum - iboats Boating Forums
Boat Trailer Tie Downs Couplers, Mounts, Hitches, Locks SeaSense Trailer Winch Shop Trailer Winches
- Questions about Onboard Battery Chargers - Boating Forum
Other than improperly securing the charger at its location and having the thing bounce around the boat the first time a good wave is encountered, about the only 2 ways to improperly install the charger would either to mis-wire the A C input if one installs a charger b head plug (which would trip a breaker somewhere), or, if the 12V output leads
- Troubleshooting Trim Gauge Sender - iboats Boating Forums
hi everyone I installed a new trim sending unit and limit switch this weekend with new wiring through the transom housing and hooked everything up I turned the key to the “On” position, and the trim gauge just stays pegged all the way up It stays that way whether key is on or off with no
|
|
|