|
- 1987 Warrior No Spark - Blue Traxx Forum
got a 1987 warrior 350, getting no spark out of the ign coil, ive done all the test and everything comes back fine, ive tried different stators, cdi boxes, rectifiers new key switch, and kill switch but i noticed that i would get 35v AC out of the red and brown wire coming from the stator
- how do i test the orange wire??? | Blue Traxx Forum
The CDI box is sending its 12V pulse to the coil, as it should, but the coil is unable to properly transform it Nothing, or an inconsistent blink of the test light, indicates that your ignition coil is not recieving its proper trigger pulse from the other components of the bike's ignition system
- Cdi wiring help - Blue Traxx Forum
My CDI box has 12 wires and I believe it is a 90-95 also my stator has 7 wires please any help is much appreciated a CDI box wiring diagram with wire description particularly would be awesome Thanks
- 94 Warrior - stator wiring CDI pinout? - Blue Traxx Forum
The orange wire out of CDI is still constant ground I don't know if this is being caused by A) the CDI itself or B) one of the inputs (clutch switch, neutral or ignition cutout relays?) to the CDI Is there a way to test the CDI itself? The pulse generator and pickup coil seemed to test within spec for Ohms
- stator and cdi wire colors - Blue Traxx Forum
Hi, For my first post does anyone have the wire colors from a 1990 91 Big Bear 350 stator and pickup? I have a CDI but the wire colors and wire plugs are different than whats on the quad The CDI 3 prong (Y B, W B, G Y) and 2 prong (B, B W) plugs match colors, however the 4 prong plug
- 01 warrior 350 NO SPARK! PLS HELP! - Blue Traxx Forum
I recently baught a warrior 350 and the owner told me he rode it then shut it off and went to ride again in the same day and no spark I put a New stator in it He had put a brand New ignition coil and cdi in it as well I tested the kill switch and I also tried bypassing the clutch safety
- 87 yamaha warrior no spark issue - Blue Traxx Forum
Now I know you can't really test a CDI BOX, but i tried the following test just to see the results Multimeter 20k volts: POS to cdi orange wire - NEG to Coil orange wire = (-1 74)- (-1 85) constantly changing volts when cranking engine over If i swap the Multimeter connecters i get a positive reading
- Have spark but still will not start - Blue Traxx Forum
2000 warrior that I replaced both the stator and cdi to get spark and all seems good in the spark department now I bought it used from a guy who had just replaced the cylinder base gasket and it had not run since Valve clearances seem right Valve timing looked like it was about 1 2 tooth
|
|
|