|
- Forum list | CJ-8
CJ-8 History Production Questions and topics related to the how CJ-8 Scramblers were originally equiped, production information, etc
- Holley Sniper EFI install on my 258 - CJ-8
I intended to take a bunch of pictures and make sure I document my experience installing the Sniper on my Scrambler I probably did not get enough pictures or take enough botes, but here goes To start off, I replaced a Holley 4bbl carb mounted on an Offenhauser intake Is it more carb than
- No fuel, wont start without priming - CJ-8
OK, last week had a rough night and ended up blowing the fusible link that comes off the solenoid Killed the whole Jeep Went back the next morning and fixed that, and when Jeep fired up I noticed my fuel lines were cracked coming off the filter (stock 1 inlet, 2 outlet) I put new fuel
- Warn AMC 20 Rear Full Float Axle - Installation Instructions - CJ-8
Scan of provided installation instructions Credit Warn Industries, Inc
- Mounting location for emblems | CJ-8
Could someone tell me exactly where the "CJ8" and "Scrambler" emblems (repros sold on this site) were originally located on the body? Did all Scramblers have these, or just certain years and or trim levels? Mine doesn't have any logos on it Thanks, Craig
- Are CJ YJ doors the same fit? | CJ-8
Or I use the full fiberglass doors made for a CJ with the glass slider windows But I find I like the YJ TJ half door combo mix better I have considered either manipulating the frame of my soft door upper to fit the contour, or finding TJ uppers for the full soft doors, and seeing if they will mate up to my YJ soft lower
- Complete Builds Restorations - CJ-8
Dedicated to complete builds, rebuilds and restoration threads from start to end
- Anyone here run a 5. 3 with an AX15 behind it? - CJ-8
If you're looking for a smaller 5 speed you may want to consider an NV3500 It's similar in rating to the AX-15 They came behind 4 8L engines It was never offered behind a 5 3 Torque rating is right around 300 ft-lbs so it won't likely stand up to sustained hard abuse behind a 5 3 Bolts right up to the 5 3 with stock parts at very reasonable prices I adapted it to the D300 using a new input
|
|
|