|
- CSB powder in 60 lb. drums - Where to buy??? | Shotgun Forum
If I recall correctly, CSB powder was available at one point in 60 lb drums? There are 8 of us at our club that are interested in purchasing a drum and splitting it up to try it out We are looking for an alternative to be held captive by the current powder cartel and thought this might offer
- CSB powder question - Shotgun Forum
Have developed sub gauge loads for CSB-1 and shared it with friends We find that charge weights to achieve 1200 fps vary as much as 2 grains Since this powder is surplus from manufacturers,it is probably "non-canister grade" requiring the end user to check and adjust loads with each new batch
- Maxam csb1 12 gauge load - Shotgun Forum
Hey all I’m looking for a load for my 12 gauge, my previous load was a rem gun club hull, 7 8oz #8 shot, 16 3 red dot powder, 209 primer and a clay buster wad Well I ran out of red dot and got ahold some csb1 I’m still pretty new to reloading and I can’t find any data for it My MEC with the
- Maxam CSB6, CSB1, CSB5 - Shotgun Forum
I don't know about CSB-6, but CSB-1 and CSB-5 are similar hue's, but do have different tints CSB-1 is a little darker, while CSB-5 is a little lighter with an every so slight green tint
- MaXam CSB-5 load results - Shotgun Forum
MaXam CSB-5 load data Listed below is my load data for the MaXam CSB-5 powder using 8 pellets of #00 buckshot cast from the Lee #00 buckshot mould, and a 7 8 ounce slug cast from the Lee 7 8 ounce key drive slug mould I could not find any load data using this powder for the loads I
- colorado sunburst anemone | Reef2Reef
California 5-6" Colorado Sunburst anemone (CSB) Sang Lee lineage I have one nice 5-6" Sang Lee lineage (CSB) Colorado Sunburst anemone available Healthy and good size! Pickup in Sacramento area or shipping is available and cost depends on zip code Please PM with any questions
- Maxam CSB5 12ga 1oz slug load data - Shotgun Forum
MAXAM CSB-5 is a fast-burning powder down in the range of, but not exactly like, Red Dot, Clays, 700X and maybe a couple of the faster Vectan numbers That along with Rep's data could help you get into the range of possible charge weights, but what might have been relatively easy will be complicated by your projectile
- Maxam CSB Powder | Page 19 | Shotgun Forum
Neither CSB-1 nor CSB-5 are suitable for 410 If you go to the MAXAM website, there is a listing of all their powders and their applications I did not see any powder they offer as being suitable for the 410 They have powders for 28, 32 and 36 gauge, but no 410 as far as I can see CSB-5 is listed as suitable for the 28 gauge
|
|
|