Support for HDSC chips (HC32F460) - Page 8 - Features - Klipper Does not seem to work the same way as with ST processors The mcu temperature is available but not through the ADC (as you pointed out) I don’t know if it will need it’s own file or if I can ‘force’ it into temperature_mcu py
Heaters dont work? - General Discussion - Klipper I have not worked on any N32 based boards; just the H32; a very different mcu The firmware for HC32F460 is not compatible with N32 based processors If the heater doesn’t work it may be the wrong pin in config or the N32 does port setup differently?
[FR] (Unkown Mainboard with HC32F460 MCU) #24338 - GitHub These machines are delivered with Marlin running on them so someone has already ported Marlin to the HC32F460 and because of the GPL license they are required to publish their modifications I know that Anycubic has been promising to do just that for a while now but haven't seen any actual code yet
MCU temperature not showing : r klippers - Reddit Hi guys, Just got my SKR 3 EZ hooked up with mainsail and I’m having trouble getting the mcu temperature to show up read despite using the below in my printer cfg file:
Voxelab Aquila HC32 Klipper · GitHub I'm having problems with Klipper saying the printer isn't ready, then after a while, it'll say it was unable to connect to the MCU, despite the fact that the terminal shows communication taking place