|
- 1G - Spectra vs Dorman oil pan. . | DSMtuners. com
SasaniFab Proven Member 2,432 784 Dec 1, 2013 Mexico, Connecticut Go to rock auto and get yourself a pioneer oil pan, made in Canada good quality pans I wasn't impressed by the Dorman
- 1G - WARNING!!!! Front Lower Control Arms; Dorman vs. Raybestos
Dorman and Raybestos both make aftermarket replacement control arms available through Rock Auto The Dorman lists for around $60 a peice, and Raybestos for around $160 a peice Recently I purchased a set of Energy Suspension lower front control arm bushings to replace the worn out stock bushings on my car
- Harmonic Balancer failure. . again NAPA Dorman | DSMtuners. com
About a month ago, i learned that my harmonic balancer had faild after investigating a wierd knock The rubber had deteriorated and the outer ring of metal had seperated and started slapping the crank case Took it off and replaced it with one from NAPA, and within a day I could hear that same
- 2G - Adjusting front camber in 2024 on 2G stock arms
The Dorman 545-010 is listed as being compatible with AWD on other sites such as Summit With that being said and us knowing that the front suspension is the same on a FWD , I’m sure they’ll fit I’ve also considered the Moog K7452 Ball Joints, but I don’t love the design of them as you’ll be adjusting caster simultaneous to camber
- 2G - RockAuto vs TRQ 1A Auto - 2g suspension rebuild
My 2g suspension is pretty clapped out, I need to replace all the ball joints, etc not included in the list are a few bushings and rear toe arms and rear trailing arms, i might be getting those in adjustable FRONT: front struts x2 inner tie rod x2 tie rod end x2 front sway bar link x2
- replace CV boot without removing axle? | DSMtuners. com
1 Purchased dorman uni-fit neoprene boot kit ($12 from rock auto) 2 Removed splash shield for better access 3 Knocked upper control arm loose with mini sledge 4 Pulled apart remainder of boot, and pulled the whole spider out of the tulip 5 Snipped off old clamps, removed base of old boot and trimmed the thick end off (as per instructions) 6
- 1g Clutch PEDAL Adjustment??? | DSMtuners. com
This may come as a shock to you, but NAPA doesn't build their own parts Whatever clutch hydraulics you recieve from them will be built by one of these manufacturers in a NAPA box: - Bendix - Dorman - Raybestos - Rhino Pac (normally made in Japan or Canada of Chinese components) - Wagner ~ Jus Rebuilding your journal bearing turbochargers since
- 1G - OEM vs Aftermarket: clutch master and slave cylinder
I've been having clutch disengagement problems for some time I've pretty much replaced the entire drive train Every parts listed below has than 200 miles I finally gave up and replaced the after market clutch master and slave cylinder I figured it must be good, since it's lifetime warranty
|
|
|