|
- EGW HD or Practical model extractor? - Brian Enoss Forums
Rather than go with the Aftec I am planning on using a more traditional built-in extractor from EGW Has anyone had experience or preferences with the two models offered, HD versus Practical? HD design may require different tension adjustment methods than is commonly used or am I wrong? Thanks
- EGW Practical Extractor - Brian Enoss Forums
Has anyone used the EGW Practical Extractor and does anyone have any feedback on it? They discontinued their regular one so the options are the new practical and the HD one I'm considering picking up one of these but wanted to get some feedback before placing an order
- EGW vs Extreme Engineering Ignition kit - Brian Enoss Forums
Been doing some research and it seems like both EGW and Extreme Engineering make good ignition kits for the 2011 platform Which would you guys prefer? Looking to get about a 2-2 5# crisp trigger pull Maybe adjust the sear spring to sub 2# after a bit of seat time
- Undersized dies - Lee vs. EGW? - Brian Enoss Forums
Anyone have experience with both the Lee and EGW U dies and can recommend one over the other? Lee apparently makes the U die for EGW to EGW's specifications so there's probably not much of a difference between the two EGW says their die is undersized by 001" while the Lee U die is undersized by
- EGW U die vs Lee U die - Brian Enoss Forums
I have EGW U dies for both 40 and 9mm and also run a FCD in 9mm The EGW is a Lee with a bit more taken off the bottom, allowing it to size further down
- Prodigy 4. 25 recoil spring with EGW guide rod kit
I have a new prodigy that I have put an EGW ignition kit, red dirt trigger, one piece guide rod, extender slide stop, mag well, and extended thumb safety Everything works well but still has an issue with not going completely back into battery occasionally I polished the feed ramp and was wondering if changing to a heavier recoil spring might
- EGW Hammer Sear necessary? - Brian Enoss Forums
I've looked at previous posts about the EGW Hammer and Sear, but I still have questions Some have posted saying that they installed the EGW sear, but kept the stock hammer They said this configuration added pounds to the trigger pull, but they hoped that adding the EGW hammer would help to make
- Took the Plunge-bought a Prodigy - Brian Enoss Forums
The EGW magazine well also slides right on The Dawson extended magazine release will come loose and jam up the gun The EGW beavertail drops right in and deactivates more reliably for me It also distributes pressure over a wider area of the web of your and, and I find it more comfortable on longer training sessions
|
|
|