|
- Swapping electric trim tilt from one BF50 to another that doesnt have . . .
My 2003 Honda 50hp recently blew a powerhead and I have been looking at either replacing the powerhead or the entire engine itself with a motor of similar vintage A 2002 Honda 50hp is for sale locally and the owner says that it does not have electric trim tilt, but my 2003 Honda has it How
- no spark | Boat Repair Forum - MarineEngine. com
I replaced the coils and powerpack and still no spark is there a way to test the ignition bits without removing them? Will a bad key switch cause this?
- Diagnostic software codes | Boat Repair Forum
On Your engine You need a capacity equal min 60 liter hour and NO air bubles in the plastic tube! Less capacity or air bubles in the plastic means touble! Remember to properly ground pump and tank and reservoir to avoid static electricity ans sparks! Comressed air backwords is not my favourite!
- Crusader 454 350hp Crossover pipe | Boat Repair Forum
the exhaust pipe between the s the exhaust pipe between the stb and port side of the engine from the risers to the muffler Its 3" dia to 4" reaching second riser before going to muffler
- Fuel mixture ratio | Boat Repair Forum - MarineEngine. com
"I am writing requesting the m "I am writing requesting the mixture ratio of fuel to 2 cycle oil in a 1963 45HP Scott Atwater boat engine if you could give info on this i would greatly appreciate it nrlpn95@yahoo com"
- Engine needs rebuilt | Boat Repair Forum - MarineEngine. com
The starboard engine needs rebuilding I understand that it is a marine version of the 350 truck engine After some calls I found a relieable shop that can do a complete rebuild This would include most of the internal parts As for the special items I can get those on line and install them as I drop the engine back in place
- Force outboard engine | Boat Repair Forum - MarineEngine. com
" I have a 1997 trophy bayline " I have a 1997 trophy bayliner with a 120hp outboard I bought it used and on the 2nd day out, the engine wouldn't start Everytime I click on to start, i could see smoke coming out of the starter Does it means that my starter is going any suggestion is
- TiltTrim Stuck Up | Boat Repair Forum - MarineEngine. com
The proper method for trailering is to have the engine in a full tilt position and resting on the trailering support bracket, then have both trim rams pulled in to a point where the engine makes a jerking motion At this point, immediately take your finger off of the PTT trim switch Now, quickly and sharply, tap the PTT up button
|
|
|