|
- no spark | Boat Repair Forum - MarineEngine. com
I replaced the coils and powerpack and still no spark is there a way to test the ignition bits without removing them? Will a bad key switch cause this?
- Fuel mixture ratio | Boat Repair Forum - MarineEngine. com
"I am writing requesting the m "I am writing requesting the mixture ratio of fuel to 2 cycle oil in a 1963 45HP Scott Atwater boat engine if you could give info on this i would greatly appreciate it nrlpn95@yahoo com"
- Ted williams 45hp model #21759464 year parts | Boat Repair Forum
"I have a Ted Williams 4 5hp m "I have a Ted Williams 4 5hp model #217-5946-4 Can anyone tell me what year it was made, and maybe where I could find some parts for it ??? Any other info or history on it would be great as well "
- 81 Johnson 90 ran fine then, hard starting and rough running, low . . .
So I got a used 81 Johnson 90 from a guy of craigslist When I got to his house, he fired up the motor and it ran nice and smooth I screwed up and didn't bring a compression tester but took a chance with how easy it fired (like first kick fire off) and idled fine I get it on my pontoon and
- Proper Impeller installation on AQ131 | Boat Repair Forum
I had overheating problems at I had overheating problems at the end of last season and it turns out that the impeller was all chewed up I bought a new one but when I placed it in the engine and started it up the engine still overheated Is it possible that I didn't have the impeller's blades
- 1989 evinrude 150 start in water issue | Boat Repair Forum
I have a 1989 evinrude 150 2 stroke that starts easily with the water muffs on but once it's dropped into the water at the lake it will not start unless brought out of the water I've already rebuilt the carbs and cleaned out the jets and fuel passages Any ideas? Thank you
- TiltTrim Stuck Up | Boat Repair Forum - MarineEngine. com
The proper method for trailering is to have the engine in a full tilt position and resting on the trailering support bracket, then have both trim rams pulled in to a point where the engine makes a jerking motion At this point, immediately take your finger off of the PTT trim switch Now, quickly and sharply, tap the PTT up button
- How to test the fuel pump on a 1998 Mercury 125 Optimax EXLPTO 4cyl?
First thing you need to know is you do not have an Optimax motor Your motor does not have an electric fuel fuel pump so you wont hear it When it starts pump the primer ball on the fuel line If the motor stays running you have a pump problem Could be an air leak or a plugged tank pick up
|
|
|