|
- no spark | Boat Repair Forum - MarineEngine. com
I replaced the coils and powerpack and still no spark is there a way to test the ignition bits without removing them? Will a bad key switch cause this?
- 1989 evinrude 150 start in water issue | Boat Repair Forum
I have a 1989 evinrude 150 2 stroke that starts easily with the water muffs on but once it's dropped into the water at the lake it will not start unless brought out of the water I've already rebuilt the carbs and cleaned out the jets and fuel passages Any ideas? Thank you
- Swapping electric trim tilt from one BF50 to another that doesnt have . . .
My 2003 Honda 50hp recently blew a powerhead and I have been looking at either replacing the powerhead or the entire engine itself with a motor of similar vintage A 2002 Honda 50hp is for sale locally and the owner says that it does not have electric trim tilt, but my 2003 Honda has it How
- Fuel mixture ratio | Boat Repair Forum - MarineEngine. com
"I am writing requesting the m "I am writing requesting the mixture ratio of fuel to 2 cycle oil in a 1963 45HP Scott Atwater boat engine if you could give info on this i would greatly appreciate it nrlpn95@yahoo com"
- Proper Impeller installation on AQ131 | Boat Repair Forum
I had overheating problems at I had overheating problems at the end of last season and it turns out that the impeller was all chewed up I bought a new one but when I placed it in the engine and started it up the engine still overheated Is it possible that I didn't have the impeller's blades
- 81 Johnson 90 ran fine then, hard starting and rough running, low . . .
So I got a used 81 Johnson 90 from a guy of craigslist When I got to his house, he fired up the motor and it ran nice and smooth I screwed up and didn't bring a compression tester but took a chance with how easy it fired (like first kick fire off) and idled fine I get it on my pontoon and
- TiltTrim Stuck Up | Boat Repair Forum - MarineEngine. com
The proper method for trailering is to have the engine in a full tilt position and resting on the trailering support bracket, then have both trim rams pulled in to a point where the engine makes a jerking motion At this point, immediately take your finger off of the PTT trim switch Now, quickly and sharply, tap the PTT up button
- 1979 Wellcraft Shifting issues. Shift interrupt switch doesnt seem to . . .
I have a 1979 Wellcraft - Merc 260 with shifting issues When in water, the boat will not shift from drive or reverse back into neutral It shifts into gear just fine, just won't shift back into neutral When OUT of water, it shifts just fine, understandably I suspect my shift interrupt
|
|
|