|
- change hosted family to non hosted family - Autodesk Community
Select the elements from the face based families (geometry, reference planes, parametric dimensions), CRTL+C, and CTRL+V align to view on the non-host family Re-constrain and add whatever is missing
- Solved: Change Family Host Type - Autodesk Community
Therefore, Families that are hosted to a Face are necessary Any of these element-specific Families can be converted to Face-Based with the following procedure: 1 Create a new Project and draw a Wall, Floor, or Ceiling - which ever element is an appropriate host 2 Load in the desired Family and place one instance of each Type on the host
- Face selection not selecting the faces that I want
I'm totally new to this and can't find a solution anywhere about this problem I'm trying to select faces however it will not select the faces that I want
- Solved: How do I flip invert faces - Autodesk Community
With the "Normals" Menu removed from the Maya Hotbox, how do I flip faces? to get the correct face to show (not show black, but show gray)
- Face based family loses host after grouping - Autodesk Community
Hello all, As the title says; I've made a face based family When I group that family with its host everything is fine But when i make a copy of the group, the copy in the new group loses its host and in this case more importantly its elevation Is there anyway to fix or avoid this? Without hav
- Solved: Remove Family host. . . . - Autodesk Community
If it is a face based family, you can still move it away from host manually Make sure to tick the box "Disjoin" and untick the box "Constrain" when you initiate the move command
- [Question] How to create a face from vertices? (Very beginner question)
3ds Max Modeling forum [Question] How to create a face from vertices? (Very beginner question) Autodesk Community will be read-only between April 26 and April 27 as we complete essential maintenance We will remove this banner once completed Thanks for your understanding We are currently migrating data within this board to improve the community
- Family Creation (Face Based versus Wall Based)
The orientation in a face based family is based on the host, so if you place the family on a wall in the project then the plan presentation set in the family is the front elevation in the project It is not that hard to figure out once you get used to it
|
|
|