|
- Firewall rules (forwarding) - OpenWrt Forum
If I go to Network > Firewall > General Settings, and set 'Forward' to 'drop' in the general settings and zones, how is it possible that OpenWRT continues to forward traffic?
- why is outlook blocking emails without my concent - Microsoft Q A
Review anti-virus firewall settings: Temporarily disable them to see if they're causing the issue Check server-side issues: If none of the above works, contact your email service provider or the sender's provider to investigate further
- How to set firewall to connect two zones - OpenWrt Forum
How to set firewall to connect two zones Installing and Using OpenWrt Network and Wireless Configuration Some-Dinosaur April 16, 2025, 10:07pm
- Firewall: time based rule not using local time - OpenWrt Forum
Disclaimer: I have no clue about nftables and the firewall settings in this regard, just picking brains here nftales not knowing about local dates and time zones would mean time based rules are fundamentally broken in nftables
- Firewall traffic rules not working after upgrading to 24. 10. 0
As the title says, after upgrading to 24 10 0 my firewall traffic rules stopped working For example, I have this rule to block cloud gaming: config rule list proto 'udp' option src 'wan' option dest 'lan' option target 'REJECT' option dest_port '49003-49006' option name 'Block-GFN-XXXX' option enabled '1' list dest_ip '192 168 X XXX' option family 'ipv4' It worked fine on 23 05 5 I even
- Firewall4 NFtables Tips and Tricks - OpenWrt Forum
Both interfaces are assigned to the wan firewall zone I'm guessing this initial fw4 implementation won't represent a 100% native nftables approach, but a way to represent the existing firewall rules in nftables I'd like to see more verdict maps and concatenations
- Firewall blocking ipv6 - OpenWrt Forum
I have 2 issues If I disable firewall completely via etc init d firewall stop then I am able to access my ipv6 entities outside network and If I restart firewall, it doesn't work to access my ipv6 entities outside the …
- Disable firewall and open all ports - OpenWrt Forum
Hello!! I would like to disable the firewall and open all the ports In the wan side of the router I have a Sophos, so I'll be fine Is the easiest way going to System > Startup and stop the service disable the firewall script? I understand that after a reboot the firewall should be disabled Is this correct? Thank you very much and best regards!! 😀
|
|
|