|
- Recommended firewall settings - Network and Wireless Configuration . . .
If you pull up Network>Firewall what are the recommended settings for "General" and "Zones?" Upon reading google hits, many are showing a "Lan -> wan" setting of "reject" for forward whereas the out-of-the-box settings have that set to "accept" including this OpenWRT wiki
- Firewall rules (forwarding) - OpenWrt Forum
The zone level forward rule controls forwarding between two or more networks that are in the same firewall zone This is intra-zone forwarding If that is set to accept, it will allow those networks to communicate with each other unless there are any other rules filtering prohibiting those connections
- PBR problems no service gateways - OpenWrt Forum
Hi, I have openwrt 23 05 on an access point, thsi access point has a single lan port that plugs into a firewall (not openwrt) Internet traffci works fine, but now im tryign t force spciefic traffci via an open vpn whe…
- Limit outgoing wan traffic from router itself - OpenWrt Forum
I'm having a bit of trouble with outgoing traffic from the router itself The goal: I want all traffic from the router itself, eg: dns, updates, packages, blocklists, ipsets to go over a vpn So I created the following firewall rules: allow vpn-connections to wan mark 0x10 ipv4 6 from this device to wan block everything from this device to wan and added a routing rule: mark '0x10' lookup '21
- Using iptables in v24. 10. 1 - OpenWrt Forum
Only manually defined iptables code firewall rules would be relevant here Anything running on the level of the UCI LuCI firewall configuration is already compliant and compatible with the iptables -> nftables migration insofar as these are higher level firewall descriptions where the underlying nftables rules are abstracted from the user
- Optimizing OpenWRT Routers for Online Gaming
For routers with 880MHz CPU, should I leave packet steering on or off? Is creating VLANs better for gaming only when you want to separate Wi-Fi traffic? Should I open incoming and outgoing ports in the firewall for my games (I usually DMZ the console PC IP)? Does IPv6 traffic put a load on IPv4? Is irqbalanced a good package for gaming? Regarding MTU, since my ISP gives me 1492, should I set
- Raspberry Pi 4 vs OpenWrt One for routing, firewall, NAS, and offsite . . .
I'm looking for server hardware to run OpenWRT and provide dedicated routing, firewall, network-attached storage access, and offsite backup (of NAS, via rclone) Internet access will be provided to the router via a Quectel RM520N-GL in a standalone modem enclosure A dedicated wireless access point will be located downstream from the router
- Mac address filtering nftables - OpenWrt Forum
I want to block all devices by default and allow specific mac addresses to access internet, and for the blocked mac addresses, i want them to access specific ip addresses or sites by default without even knowing the mac addresses before hand How do i achieve this using nftables?
|
|
|