|
- Wireless LAN FlexConnect Configuration Example
Introduction FlexConnect is a wireless solution for branch office and remote office deployments Prior to WLC Release 7 2, FlexConnect was referred as Hybrid REAP (HREAP) Now it is called FlexConnect FlexConnect feature enables customers to configure and control Access Points through a wide
- whats the difference between local mode and flex-connect mode on AP
Flexconnect mode is the combination between autonomous IOS APs and the local mode, Cisco made this mode basically for WAN connections where the link is usually less stable than LAN
- 【公开课】第四十三期——思科无线 FlexConnect 技术介绍 - Cisco Community
思科社区【公开课】活动是思科社区（Cisco Community）推出的每月一期的在线技术讲座活动。每期我们都会邀请到思科内外部技术支持专家，通过在线视频讲座，为大家讲解热门技术主题，分享故障排错、最佳实践、客户案例等。 本期我们有幸再次邀请到 乾颐堂网络实验室 创始人，从业十余年的资深
- Conheces o FlexConnect? - Cisco Community
Os APs FlexConnect podem processar o tráfego de dados do cliente localmente e realizar autenticação de cliente localmente quando a conexão com o controlador é perdida Quando estão conectados ao controlador, também podem enviar tráfego de volta para o controlador No modo conectado, o AP FlexConnect também pode realizar autenticação
- 【CSC公开课】问题汇总_使用思科FlexConnect技术构建分支机构WLAN网络 - Cisco Community
在部署flexconnect 方案的local swtching模式下，要求无线全覆盖，只提供两个不同的SSID ，一个给内部员工，另一个给guest使用。有如下几点疑问： 1，分支机构两个SSID 对应的vlan采用不同的vlan、不同的子网，是否可以实现？？ 2，采用flexconnect local swtching部署，首先采用central 认证，AP与AC中断后，如何把
- FlexConnect (HREAP) --简要环境搭建 - Cisco Community
HREAP - Hybrid Remote Edge Access Point - 混合远程边缘接入点 <<<<7 2 130 之后HREAP被FlexConnect取代 是为企业的分支机构及远程办公室AP部署的一种设计方案。它让客户在公司办公室可以通过WAN配置并控制分支或远程办公室的AP访问点，而无需在每个办公分部都部署无线控制器。当HREAP与远程总部的控制器失去连接
- Catalyst 9800 に帰属した AP をローカルモードから FlexConnect モードに変換する方法
本ドキュメントでは、Catalyst 9800 に帰属している AP をローカルモードから FlexConnect モードに変換する方法を紹介します。 注：AP でサイトタグを変更すると、9800 WLC への関連付けが失われ、再度参加する必要があることにご注意ください。
- FlexConnect Split Tunneling - Cisco Community
Split Tunneling - Introduction When a client is connected over a WAN link associated with a centrally switched WLAN wants to send some data to a device in local site, then the client has to send the traffic over CAPWAP to the controller and then get the same data back to the local site over CAPW
|
|
|