|
- FIX Incompatible Gimball Error 40021 on Mavics (02-2020)
Hello everyone After changing the Gimball on Mavic mini1 and Power ON, the Gimbal is not in the correct position with DJI Fly screen messages: Incompatible
- Gimbal overloaded - quick fix? | DJI Mavic, Air Mini Drone Community
You can cut the flat black ribbon cable on the gimbal and that will cut power to your gimbal motors Dont cut the silver stranded cable, thats your video feed If you decide to cut the black cable, you will need to fix the gimbal into one position with tape, gauze or other contraption Thanks for the suggestion Is this the ribbon?
- Cannot move the gimble left right or up down - DJI Mavic, Air Mini . . .
The gimbal before I was able to fix the focus and aperture issue was moving left right up down just fine It can fly normally, but again, the camera is facing forward non stop
- Error code 40011 | DJI Mavic, Air Mini Drone Community
But when i got it home n flew it, the gimbal wont move and it shows me error code 40011 I can fly the drone properly without problems, but cant move the gimbal with the remote
- Air 3s Gimbal Overload warning and now Gimbal Stuck
Tried a gimbal calibration and it would not complete past 60% I left it over night and this morning I have appeared to only make it work as now it says gimbal stuck and gimbal reset only makes it to 40% On start up the gimbal does not appear to go through it system check Here is what I have done
- Mavic Mini Error 40012 + 30066 after Flex Ribbon Cable replacement
Hi Guys, I've bought an Mavic Mini where the Ribboncable to the Gimbal Yaw motor driver board was broken tattered I've ordered an replacement cable and replaced it, all plugs are plugged in fine but unfortunately I am getting these errors: "Gimbal unable to connect Repairs required Contact
- DJI Mini 3 Pro small crash Gimbal Motor overload?
Hello all I was testing the Mini 3 Pro obstacle avoidance, it failed and dropped to the floor, about 6ft high, very slow After this I have a Gimbal
- Mavic Air 2 2S Mini 2 Mini3 gimbal replacement
Can I purchase a new gimbal, remove the camera module from it, and install my old camera into the new gimbal? That way, I have the paired camera in the new gimbal or is that not how it works? It would depend on how the gimbal is assembled I haven't opened up an Air 2 gimbal
|
|
|