|
- HDDScan: Testing a hard drive putting it through its paces . . . - Reddit
I've seen people recommending HDDScan to test a new hard drive before putting it in use What I'm wondering is which tests should I run?
- New HDD Test : r DataHoarder - Reddit
Is this the correct order of things, or should I do one of the tests in HDDScan? —— NOW, on the other hand I have WD 2Tb blue HDD with a current pending sector count 97 97 000000000051 current worst raw
- HDDScan VS CrystalDiskInfo | How bad is this drive? - Reddit
HDDScan VS CrystalDiskInfo | How bad is this drive? Hi, i'm testing one hard disk with two different software: HDDScan and CrystalDiskInfo HDDScan reports about 2266 bad blocks, CrystalDiskInfo gives me a yellow warning and "current pending sector count" of 1 Why are the results different? How bad is this drive?
- HDDScan: Verify Test Running 10x Slower than Read : r DataHoarder - Reddit
I ran an Erase test with HDDScan, which ran with a speed of roughly 100 MB s But, the Verify test only ran at roughly 10 MB s before I stopped it at around 20% done
- HDDScan VS CrystalDiskInfo | How bad is this drive? : r homelab - Reddit
HDDScan VS CrystalDiskInfo | How bad is this drive? Hi, i'm testing one hard disk with two different software: HDDScan and CrystalDiskInfo HDDScan reports about 2266 bad blocks, CrystalDiskInfo gives me a yellow warning and "current pending sector count" of 1 Why are the results different? How bad is this drive?
- HDDScan showing gt;500ms blocks on new hdd : r DataHoarder - Reddit
I also have the SMART status from CrystalDiskInfo after running completing the test on HDDScan Few questions: Is my new hdd healthy? Should I return it? Why do the same blocks have different latency reading in different tests? From the graph, it can be told that the reading speed is slower as the LBA value increases Is this normal?
- HDDScan Verify test and Read test are giving me very different . . . - Reddit
Hi all, I recently bought a Toshiba 4TB HDD and before I put it in use, I decided to run an HDDScan test on it I first run a verify test and almost all of the blocks are >150 ms, so very slow
- Help troubleshooting GoHardDrive refurb and test utilities
HGST 12TB HDD (2ALE601) - primary drive I want to test WD 320GB HDD (WD3200AAKS) - secondary drive HDDScan 4 1 0 29 h2testw 1 4 smartmontools 7 2 First ran a SMART report via CrystalDiskInfo which looked good, only 26k hours and clean report with no errors warnings So then I tried running HDDScan's write zero test as recommended on r DataHoarder
|
|
|