|
- HFSS Sweeps:Discrete vs Interpolat vs. Fast - Forum for Electronics
HFSS interpolation in high frequencies is always superior to that of a circuit simulator 3)Discrete Sweeps Discrete sweeps are rarely used Some engineers that require only 5 or 10 frequency points claim that discrete sweep may be faster Discrete is the only sweep where the simulation time is proportional to the number of frequency points
- [SOLVED] - HFSS question- what is PML used for?
Dear All, I have a question in HFSS: What is 'PML' used for? Actually I need to extend a dielectric box in half space so I used Master slave on its sides but I don't know how to extend the bottom side to infinity as doing this by just increasing length can take very long time and even the PC
- HFSS number of passes | Forum for Electronics
HFSS uses adaptive meshing, which is to say that it sets up an initial mesh, solves the fields, and then re-meshes based on where the fields have a high concentration and or gradient Each re-meshing step is called an "adaptive pass" Importantly, at each step, the scattering parameters are evaluated at each port, and compared to the previous step
- How does HFSS calculate Z Parameters? - Forum for Electronics
Hi, I am new to HFSS (a few weeks ago I was asked to learn it without any prior knowledge of it or antenna simulation), and I have a model of an Interdigitated Capacitor, which we are trying to find the capacitance of I have a lump port across the two "digits" for an excitation and I recently
- how to draw triangle in HFSS? | Forum for Electronics
1,283 Activity points 1,471 equation based surface hfss Salam I have used the HFSS, though not much Still I am learning about it According to my experience you can not draw the triangle it self But if you want to make some conical shape that is possible As in the case of horn antenna just it is matter of conecting the surfaces Regards Asim
- An Introduction to HFSS - Forum for Electronics
Launching Ansoft HFSS To access Ansoft HFSS, click the Microsoft Start button, select Programs, and select the Ansoft, HFSS 12 program group Click HFSS 12 Setting Tool Options To set the tool options: Note: In order to follow the steps outlined in this example, verify that the following tool options are set : Select the menu item HFSS Options
- How to define ports for CPW in HFSS? | Forum for Electronics
How to find the resonance frequency and impedance of a planar spiral coil in HFSS?
- microwave absorber modeling in HFSS | Forum for Electronics
So what do you need help with in HFSS? i think there is a way in HFSS to attenuate a signal maybe with PML or something else my problem is attenuating signal in simulation maybe with modeling an absorber in HFSS and put in the back of antenna or using a way to attenuate backlobe
|
|
|