|
- 1967 Plymouth GTX door removal | For B Bodies Only Classic Mopar Forum
Hello All! I am restoring a 1967 GTX 4spd and need to take off the driver door to send to paint shop for a repaint I see that there are 5 bolts between 2 hinges is that all I need to do, other than mark around the hinge so I know where to place when reinstalling
- Door alignment? - For B Bodies Only Classic Mopar Forum
Rubber mallet and BFH - Help move stuck hinges or ???? Pieces of heater hose - Strategically placed between a section of door and body and used as a tool to deform the metal by forcefully closing the door on the piece of hose
- Door Hinges - For B Bodies Only Classic Mopar Forum
Door Hinges Hi guys I rebuild only MOPAR door hinges using only MOPAR cores No imports or Taiwan stuff I use only new, US made high quality components I do a COMPLETE rebuild Not a pin bushing butcher job I buy good used cores I give a discount to all members of FABO, FBBO, FEBO PM me for all
- Hood hinges | For B Bodies Only Classic Mopar Forum
I'm curious if the hood hinges need grease? I am still working on the body work and I notice that sometimes the rear of the hood doesn't seat all the way down when I close the hood I have the hinges at the rear seated downwards otherwise the hood would even be worse on closing I can push
- Door Hinge Repair - For B Bodies Only Classic Mopar Forum
The standard oversize is 375 and the max oversize id 409 The brass bushings never intended to support weight Ever wonder why the factory only used the oil-ite bushings on the top hinges ? Bet you had a hard time drilling the door side of the hinge, wait you don't have to with the bushing kit because it goes on the soft body side hinge half
- 4 door parts same a 2 door parts? - For B Bodies Only Classic Mopar Forum
What all will change out hood,trunk fenders? Any of the floor pans?on a 66,67 models also what about 66 to 67 parts? I have 67 2 door looking at a 66 4door parts car will hood,fenders trunk be right?
- Rebuilding door hinges - For B Bodies Only Classic Mopar Forum
Finally planning to get back to a few maintenance and repair items on my car - one being to replace the bushings and pins in the door hinges Question is - any tricks of the trade or tools to use to remove the lower hinge springs and reinstall them? Thanks for any help that can be provided
- Fiberglass Hood (Bolt on) Lighter Springs Hinges?
One of the hood suppliers actually sells lighter springs VFN or Glasstec Right now I have no springs on the hinges at all The springs do two things, they hold the hood UP and then they pull the back corners DOWN so the hood fits flush at the rear With no springs you have to push the back down after closing the hood
|
|
|