|
- Chevy C60 Help | Heavy Equipment Forums
Does anyone have experience in replacing hydrovacs on a Chevy or GM medium duty truck? I'm told that I may need a pressure bleeder after I change it out, and that even with this, it's hard to bleed air out of the brakes My local mechanic said he could swap this out for $750 which seems a little
- CAT HYDO Hydraulic Oil Alternatives? - Heavy Equipment Forums
An SAE10W hydraulic oil from any reputable oil company (Mobil, Shell, Conco, etc) would be my suggestion They will all produce an oil of an equivalent specification to Cat HYDO 10W Mobil used to produce the oil for Cat, I'm not sure if they still do Look for any oil that passes the Eaton Vickers 35VQ25 Vane Pump test, that is a good guideline Beware of spec sheets that say "designed to
- bobcat 753 hydrolic oil pressure warning light - Heavy Equipment Forums
i have a bobcat 753 skidsteer the hp-1 and hp-2 warning light keeps coming on when im trying to warm it up i have changed the hydro filter and toped off the hydrolic tank and i went threw and sprayed all the wire connecters with electrical cleaner and that light keeps coming on I dont know if
- 963 hydro leaking internally? - Heavy Equipment Forums
I'm finnally starting to work on my 963 Its problem (I believe) is that the hydro oil is getting clear into the flywheel case and coming out the breather Is there a "flywheel case" and then a "gear case"-going from the engine back- and then the hydro? There are 2 breathers on top- one on the
- Hydraulic tank pressurizing problem - Heavy Equipment Forums
We have a dump truck with a Hyva cylinder in it Tank is mounted behind the cab Hydro keeps coming out through the fill cap breather About once or twice a week we need to top off the hydraulics My assumption is that somehow air is getting sucked into the hydraulic system, pressurizing the
- Ideas to remove stuck hydro cylinder pin on forklift?
He's trying to avoid lots of heat and flame - and with good reason Everything on forklifts is a tight clearance, and there will be any amount of easily damaged components and hoses right near to the pin A small hydraulic press ram, blocked up and pushing from the opposite side of the forklift (if there's room) is also a suitable option Even a 10-ton body repair hydraulic cylinder might be
- Vacuum Truck Question - Heavy Equipment Forums
Average speed for most vacuum pumps is 1000 to 1175 RPM What is the brand and size of your pump? ( Wallenstein, Moro, Demag, Challenger, Mosport) The manufacturer will have a recommended speed Get this info and i might be able to help We run, fix and build them all the way from portable toilet trucks to hydro vac trucks :thumbsup
- Leaking Hydraulic Coupler - Heavy Equipment Forums
I assumed the seal around it was leaking, but after discovering the hydro oil leaking out of the coupler, I figure it is dripping down onto the hose (shown in pic) and ending up around the front face of the hydraulic arm (also shown in pic)
|
|
|