|
- Inconsistent address and mask - Cisco Community
Hello guys, I new at this, I start studying CCNA and now I am at the beginning with CCENT I made a simple topology in Packet Tracer: 1 PC, 1 Laptop, 1 Switch, 1 Router,1 Server I will attach a photo of it I used the IP 192 168 100 1 to the interface of the router who binds the LAN and the mask 255
- Inconsistent Peer VLAN ID - Cisco Community
I'm having some trouble trying to figure out why I'm getting the following errors in my logs This morning, for the first time in over a year, my switch stopped communicating with my core switch, so I checked the log Feb 27 16:25:15 364 UTC: %SPANTREE-2-RECV_PVID_ERR: Received BPDU with inconsi
- Solved: Inconsistent peer vlan c9500 issue - Cisco Community
Start a conversation Cisco Community Technology and Support Networking Switching Inconsistent peer vlan c9500 issue Bookmark | Subscribe
- Provision Catalyst 9300 switch to Catalyst Center - Cisco Community
PKI Config push Failed - Unable to push configuration to device ip x x x x Device response - inconsistent value: Device refused one or more commands This means a command (or more) in the template is incompatible with the 9300 If the template works with 3650 3850, start checking the uplink config because this could one of the culprits
- Solved: %Inconsistent address and mask - Cisco Community
inconsistent ip and mask 0 Helpful Reply Georg Pauwen VIP In response to genefrehleyjaleco404 Options 10-18-202006:29 AM Hello, what is the context of your question ?
- Received BPDU with inconsistent peer vlan id 2 on Port-channel3 VLAN4
Inconsistent peer vlan " "Blocking Port-channel3 on 4 Inconsistent peer vlan " The port channel2 on switch "A" is in reality one singular port, and the switch "B" on the other end of the cable also has a port channel composed by only one port This applies to this specific switch connection and all the other switch links towards switch "A"
- Port Channel Load Balancing Issue – Inconsistent Output Interface
The `port-channel load-balance internal` command on Nexus 9k switches configures internal load balancing within port channels, and its default value dynamic load balancing might influence traffic distribution In your scenario, where vPC-connected switches forward packets of the same flow via different interfaces, this could result from dynamic load balancing To ensure consistent egress paths
- Solved: C-NIM-4X VPN service error - Cisco Community
Not only L2 The C-NIM-4X is a Next-Generation 1G 10G LAN WAN module with local Layer 2 switching capabilities on all four ports This provides a price-effective, low-density 4-port Layer 2 LAN switch with capacity for switching four Small form-Factor Pluggable (SFP) SFP+ ports at speeds up to 10 Gbps The two highest-numbered ports can be configured for native Layer 3 operation Configuring
|
|
|