|
- Provision Catalyst 9300 switch to Catalyst Center - Cisco Community
PKI Config push Failed - Unable to push configuration to device ip x x x x Device response - inconsistent value: Device refused one or more commands This means a command (or more) in the template is incompatible with the 9300 If the template works with 3650 3850, start checking the uplink config because this could one of the culprits
- Inconsistent Peer VLAN ID - Cisco Community
I'm having some trouble trying to figure out why I'm getting the following errors in my logs This morning, for the first time in over a year, my switch stopped communicating with my core switch, so I checked the log Feb 27 16:25:15 364 UTC: %SPANTREE-2-RECV_PVID_ERR: Received BPDU with inconsi
- Received BPDU with inconsistent peer vlan id 2 on Port-channel3 VLAN4
The switches are not rebooting or having links that change status before the appearing of the log "Received BPDU with inconsistent peer vlan id 2 on Port-channel3 VLAN4" so I'm at a point that thinking about something else is becoming difficult
- Solved: %Inconsistent address and mask - Cisco Community
Start a conversation Cisco Community Technology and Support Networking Switching %Inconsistent address and mask Bookmark | Subscribe
- 已解决: 生成树问题，日志总是有这个错误！ - Cisco Community
Inconsistent peer vlan %SPANTREE-2-RECV_PVID_ERR: Received BPDU with inconsistent peer vlan id 100 on GigabitEthernet0 49 VLAN1 0 49口是trunk口，对端和本端的本征native都是vlan1，需要怎么配置才不报这个错误，谢谢各位大神 我也有相同问题 标签: 其它交换相关 4 有帮助
- Solved: spanning tree root guard command - Cisco Community
in my LAN the all access layer switchs stacks are connected directly to core backbone switch (cisco 6509) via sfp fiber-optic i want to protect my spanning tree setup with the "root guard" command 1 where would i set this ? on uplink ports on access layer switches ? or on core backbone ports to
- Inconsistent address and mask - Cisco Community
Hello guys, I new at this, I start studying CCNA and now I am at the beginning with CCENT I made a simple topology in Packet Tracer: 1 PC, 1 Laptop, 1 Switch, 1 Router,1 Server I will attach a photo of it I used the IP 192 168 100 1 to the interface of the router who binds the LAN and the mask 255
- %SPANTREE-2-BLOCK_PVID_PEER: Blocking Inconsistent peer vlan
Hello Comunity! Spanning Tree %SPANTREE-2-BLOCK_PVID_PEER: I know there are a lot of posts about inconsistent peer VLANs being blocked But in my situation, both switches are in the same mode "Switches are in Rapid PvST mode", all VLANs are allowed on the trunks, and both switches have the same VLANs
|
|
|