|
- Solved: Inconsistent Peer VLAN ID - Cisco Community
I'm having some trouble trying to figure out why I'm getting the following errors in my logs This morning, for the first time in over a year, my switch stopped communicating with my core switch, so I checked the log Feb 27 16:25:15 364 UTC: %SPANTREE-2-RECV_PVID_ERR: Received BPDU with inconsi
- Solved: %Inconsistent address and mask - Cisco Community
Our ISP has set up a modem at our location with the following IP and subnet: ip 96 74 187 50 mask 255 255 255 252 I'm trying to put in an ip route to the next hop which is our firewall switch> ip route 96 74 187 50 255 255 255 252 10 10 22 5 when I do this I get %inconsistent address and mask We wer
- 生成树问题，日志总是有这个错误！ - Cisco Community
If the port stops receiving inconsistent BPDUs, the *-inconsistent state is cleared and STP changes the port state based on normal STP operation A syslog message is sent to indicate the change: %SPANTREE-SP-2-UNBLOCK_CONSIST_PORT: Unblocking FastEthernet0 1 on vlan 1 Port consistency restored 具体请参考
- Solved: Fatal error during installation. A VPN connection cannot be . . .
Yes: The AC install typically fails with this REG FIX: “Computer\HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\DeviceInstall\Parameters\DeviceInstallDisabled” : If you ensure this registry key is set to 0 it will solve
- Solved: SPANTREE-2-LOOPGUARD_BLOCK - Cisco Community
Determine why devices that are connected to the listed ports are not sending BPDUs One reason could be that they do not run the Spanning Tree Protocol; in this case, you should disable loop guard in the inconsistent interfaces or start the spanning tree protocol on the other side of the links, depending on the context
- Provision Catalyst 9300 switch to Catalyst Center
PKI Config push Failed - Unable to push configuration to device ip x x x x Device response - inconsistent value: Device refused one or more commands This means a command (or more) in the template is incompatible with the 9300
- Solved: Inconsistent port type error on VLAN - Cisco Community
%SPANTREE-7-BLOCK_PORT_TYPE: Blocking GigabitEthernet0 0 0 on VLAN2 Inconsistent port type ***** From what i suspect, this is happening because the port from the ISP2 is in trunk mode and my own port is access mode as shown in the config file I have tried to apply bpdufilter but i can’t get the command to work on the router
- loopguard技术 - Cisco Community
loopguard：防止一个阻断的端口由于链路不正常（不能双向通信等）当网络的链路出现拥塞或是短时间内cpu处理能力不足，造成在max-age左右的时间接不到BPDU后变成转发，配了此项后，即使接不到BPDU也是阻断的loop-inconsistent blocking state（启用loop guard时自动关闭root guard）； Loop guard在RP接口或替代端口
|
|
|