|
- Arduino Nano - Linx - Multiple Analog Read - NI Community
I am using an Arduino nano, i have an LDR connected to A0 and a TMP 37 temp sensor to A1 I managed to get the program to work when the the output resource of the first analogue read then goes into the "in" of the second analogue read, then output of that goes into the close vi The issue i had
- Hobbyist Toolkit - NI Community
Show: All - Answered - UnansweredPrevious 1 2 3 … 15 Next
- [LabVIEW Tutorials] Programming an Arduino using LINX
LabVIEW Basics #2 - Servo Control with an Arduino using LINX How to manually control a micro servo and adjust its pulse width
- [LabVIEW Tutorials] Programming an Arduino using LINX
Linx Hobbyist comes with already built firmware for the arduino that works with the labview API Once you go through the device setup from the tools menu entry you'll have an arduino that works with the toolkit
- LINX on Arduino R4 WIFI - NI Community
The Arduino UNO R4 WiFi uses a Renesas RA4M1 microprocessor I believe LINX and the more recent LabVIEW Hobbyist Toolkit only supports ATMega based Arduinos So until NI adds support for the Renesas micro it's not going to work
- Labview + Linx + Arduino Mega 2560 Pro Mini = Error 5001
The Linx Firmware Wizard loads smoothly using like the normal Mega 2560 model board As the Mega 2560 Pro Mini is the same processor and they are compatible, I thought I would have no problems I tested it on compatibles Uno R3 and nano v3 0 and whatever type of board selected in the Firmware Wizard for them, it works the same
- LINX Toolkit Open-Sourced? - NI Community
Sam and supposedly others were continuing on Linx while at Digilent but somewhere around 2016 this pretty much stopped until it was revived for inclusion into the LabVIEW Community Edition in 2019 At least since that time it was fully open source on github but most likely it was before, I just didn't happen to hear about it
- LINX - Blink (Simple). vi is not working with HC-05 over bluetooth com . . .
OK, installing the Digilent LINX package on top of LabVIEW 2020 Community Edition may be your issue LabVIEW Community Edition already comes with LINX installed and the package in package manager is known to cause issues when installed on top of the Community Edition
|
|
|