|
- Transmission Fluid Level Check 2003 Toyota Tundra SR5 4 . . . - CarCareKiosk
The engine in your 2003 Toyota Tundra should be running when you perform a transmission fluid level check, otherwise it will be inaccurate The video above shows where the transmission fluid dipstick or the transmission fluid check plug is located in your Tundra and how to check the transmission fluid level
- Transmission fluid check - Toyota Tundra Forum
Check fluid level after truck is fully warmed up, after driving a few miles You check WHILE THE ENGINE IS RUNNING, IN PARK There is a Hot and Cold range on the dipstick The cold range is only for reference when refilling a tranny If you need to add fluid, you use a long skinny funnel and do it through the dipstick hole
- Checking Auto Trans Fluid - Toyota Tundra Forums
There are two reasons you check the fluid 1) checking level and 2) checking color change and clarity which indicates condition You'll find it's a LOT easier to check the fluid when it's cold as it's sooooo much easier to read The catch is that you have to know where the "cold and stopped" mark is
- Where do you check the transmission fluid on a Toyota Tundra?
To check the transmission fluid on a Toyota Tundra, you will need to follow specific steps since the transmission is a sealed system and does not have a dipstick Here’s how you can check the transmission fluid level: 1 Start the engine and let it idle for a few minutes to warm up the transmission fluid 2
- Transmission fluid level check - Toyota Nation Forum
Check the transmission fluid while the engine is running Let it run (it's best to actually drive it) for about 20-30 minutes and then check it while it's running Park the car on level ground and go through each gear selection on the shifter while counting to 2 each time
- Check Transmission Fluid: Why The Engine Has to Be Running
Checking the transmission fluid while the engine is running and at the correct temperature is also essential to ensure that the fluid is not being measured in an expanded state that would give a false high reading
- Checking Transmission fluid? - Toyota Tundra Discussion Forum
With the engine idling and the parking brake applied, shift the selector into all positions from "P" to "L", and then shift into "P" position Pull out the dipstick and wipe off the fluid with a clean rag Re-insert the dipstick and check that the fluid level is in the HOT range
- Why You Should Check Transmission Fluid When The Engine Is Running
Q: Why add transmission fluid when the engine is running? First, you should always check transmission fluid with the engine running so that the torque converter gets filled with fluid and removes the excess, so you get an accurate reading
|
|
|