|
- TN-28 2014 - Guide to Differences in Pressure Rating PE Water Pipe . . .
The purpose of this technical note is to provide important information available to PPI on describing the differences in the calculated design pressure for water piping applications using the ASTM PPI and ISO pressure-rating methods
- TECHNICAL SPECIFICATIONS - Arctic Pipe and Utilities
All core HDPE pipe and fittings shall conform to standard iron pipe size outside dimensions (IPS), have a wall thickness meeting SDR 11, and have a minimum pressure rating of 160 psi according to ASTM D2837 at 73°F with a service rating of 0 5
- Pipeline Plastics - Water Tech Data Sheet
Pipeline Plastics Water Pipe is manufactured using a high performance PE4710 compound meeting the demanding require-ments and rigors of water transmission, distribution and sanitary sewer
- IPS HDPE Pipe Chart - GF Piping Systems
Pipe weights are calculated in accordance with PPI-7 TR-7 Average inside diameter is calculated with nominal OD and minimum wall thickness plus 6% Actual ID’s will vary and are controlled by the dimensions and tolerances listed in the applicable pipe specifications
- WL Plastics PE3408 HDPE Pipe Determining Pressure Ratings for Applications
WL Plastics pressure rated HDPE pipe is manufactured from engineered polyethylene compounds that provide a unique balance of short-term and long-term properties for pressure pipe applications
- WL106 PE4710 PE100 Pipe Compound
WL Plastics PE4710 PE100 polyethylene pipe compounds are Listed by PPI in TR-4 and are stress rat-ed for pressure pipe with PPI HDS ratings for water at 73°F (23°C), PPI MRS ratings for water at 68°F (20oC) and PPI HDB ratings at 73°F (23°C) and 140°F (60oC)
- The Performance Pipe Field Handbook - Chevron Phillips Chemical
This Field Handbook contains selected information that is excerpted and summarized from the PPI Handbook of Polyethylene Pipe and Performance Pipe literature
- PPI Listing of - plastic pipe
This report lists thermoplastic piping materials with a Plastics Pipe Institute (PPI) recommended Hydrostatic Design Basis (HDB), Strength Design Basis (SDB), Pressure Design Basis (PDB) or Minimum Required Strength (MRS) rating for thermoplastic piping materials or pipe
|
|
|