|
- Will Micropython replace embedded C | Forum for Electronics
I am new to embedded programming Would like to know the future of Micropython c Will micro python completely replaces embedded C As a budding programmer do I need to concentrate more on Embedded C or Micropython
- esp32 micropython and proteus | Forum for Electronics
Bonjour, I'm French, please excuse my English After some research, I can't simulate an ESP32 card equipped with the micropython interpreter in Proteus Is it possible? If so, is there a tutorial to help? Thank you very much Xavier LOUIS
- [SOLVED] - ESP32-S3-A7670E-4G | Forum for Electronics
I'm trying to write and read from the sdcard, in the code snippet that follows I have doubts about how to define the pins of my esp32-s3-a7670E-4g
- Rasp Pi pico and AD9834 DDS chip | Forum for Electronics
I load this into my micropython program, run the program, load the LSB first into the AD9834, then MSB it starts OK but my actual freq is 13 mHz I get a nice sine wave, 200 mV peak to peak, but wrong freq I am pulling my hair out trying to figure this out, I checked and rechecked my LSB MSB calculation several times , I know those are right
- Using MCP 2221 with Python | Forum for Electronics
Hi, I normally use PIC 16F Microcontroller with MCP 2221 which serve as UART to USB bridge The MCP 2221 device appear as Virtual Com and I just need to set Baud Rate in Putty to start communication PIC 16F Microcontroller I guess UART to USB falls into CDC class I want to try MCP 2221
- Questions and Problems by DS1307 RTC | Forum for Electronics
Hi Everyone, It has been a few days that I have been struggling with DS1307 RTC and I have some questions and problems I should mention I had tested a library for ds1307 on its prepared module, then I decided to make the circuit separately with its components These are the ds1307 module pic
- [SOLVED] - proteus 8 professional simulation difficulties!
Please can someone please help! I am new to proteus simulation and currently trying to simulate a simple led ON-OFF project I wrote my code using MPLAB X
- How to simulate SX1278 LoRa module - Forum for Electronics
Hi Friends, I want to simulate a LoRa module I don't care about the specific module (Ra-01, Ra-02, etc ) I tried Proteus, Altium, and KiCad but couldn't simulate it Although KiCad had some LoRa modules, none of them had a simulation model I understand that working with the actual device is
|
|
|