- Understanding the 75°C vs 90°C column in Ampacity Table. . .
The columns indicate how much amperage is required to raise the temperature of that size conductor to that column's temperature under standardized conditions So a 2 0 XHHW will reach 75°C at 135A and 90°C at 150A The wire insulation is good for 90°C, so for sizing the wire, we can use the
- NEC Requirements for Generators and Standby Power Systems
NEC Requirements for Generators and Standby Power Systems Rule 220 87, Articles 445, 700, 701, and 702
- High bays hanging from rigid conduit - Electrician Talk
My AI NEC assistant tells me this is permissable Yes, the National Electrical Code (NEC) allows luminaires (light fixtures) to be supported by a chain from a rigid conduit under specific conditions
- EMT Fittings for Damp Locations. - Electrician Talk
Here’s 2023 NEC Same wording I included the Enhanced Content 225 22 Raceways on Exterior Surfaces of Buildings or Other Structures Raceways on exteriors of buildings or other structures shall be arranged to drain and shall be listed or approved for use in wet locations ENHANCED CONTENT If raceways are exposed to weather or temperature changes, condensation is likely to occur, causing
- Equipment room receptacle. - Electrician Talk
NEC 2020, 210 63 (B) now requires a receptacle outlet in electrical rooms containing panelboards, switchboards, or switchgear The intent is to ensure there’s a convenience outlet for servicing the electrical equipment (like plugging in test equipment, task lighting, or even a laptop)
- What are appliances and when is a disconnect required?
So appliances, as defined by the NEC, are equipment for HVAC, clothes washing, electronics, food, lighting, chemicals, or "similar purposes" which are installed as part of, or in connection with, an electrical installation Which is basically everything you could possibly install in a residential setting
- 210. 8 (F) Outdoor Sauna 2023NEC - Electrician Talk
I am mainly looking for opinions here I feel best leaving GFCI protection installed however in the eyes of the NEC would 210 8 (F) apply since the “outlet” is the heater which is located INSIDE of the structure? This world is held together with tape, glue and hope
- Line load same conduit - Electrician Talk
Is it against nec to run line and load in the same conduit to A fused 30 amp disconnect ? Running line and load in the same conduit is generally fine as long as it's rated for the ampacity and meets NEC requirements Proper separation and conduit fill calculations are key to avoid overheating I was unsure about ordering a paper online, but my classmate told me to check the DoMyPaper samples
|