|
- What is ammonia NH3 NH4? - seneye
NH3 and NH4 together are often referred to as total ammonia nitrogen (TAN) Under normal conditions, NH3 (ammonia) and NH4 (ammonium) will both be present in aquarium water The two exist at an equilibrium point that is governed largely by pH and temperature However, salinity and the ionic strength of the water also influence this equilibrium
- what ammonia level is safe - seneye
NH3 is reported in the unit of ppm but this is interchangeable with mg L as it is a gas dissolved in water Want to reduce your ammonia because you have a high level or problem?
- NH4 and NH3 calculations tables - seneye
Using traditional methods free ammonia (NH3) is very hard to measure so normally people measure non-toxic ammonium (NH4) in the aquarium and pond and use this as a guide to safe levels of NH3
- Fitting and registering your seneye slide
The seneye slide is for your NH3 and pH readings; without a valid slide fitted you will not receive SMS alerts You will need to soak your slide in the water it will monitor before fitting it so that it stabilizes: 24 hours before for freshwater and 48 hours before for salt water You can soak your slides in a container of the system water
- Is my seneye+ slide damaged - Seneye
Stained Slides Some chemicals may stain the sensor pads rather than harm the chemistry, and since a Seneye sensor calculates pH and NH3 values based on the colour of the sensor pads, this can affect the accuracy of readings The sensor pads on a slide stained by chemicals may be a colour other than yellow or olive green, and the colour may be discontinuous with a sharp divide We believe that
- Photometer and reagent ammonia tests - seneye
NH3-N test kit ouput ammonia measurementIf you are using a Photometer or Reagent test that measures NH3-N or TAN then care needs to be taken to understand exactly what is being measured There are a number of test methods that measure "Ammonia" NH3 however, it is not always as simple as reading the value Is an Ammonia or NH3 test kit reporting the same NH3 value as seneye? In short, No: Why
- seneye slide NH3 pH
The NH3 is the most likely to be damaged and it will turn grey and give false high readings If you think you have damaged your slide through mishandling then simply fit a new slide Q When I remove my device from the aquarium it shows a higher pH when dropped back in Why? A
- reducing ammonia NH3 levels - seneye
We know high levels of NH3 (ammonia) is harmful to fish in the aquarium or pond but reducing them can often be a problem Please follow this link to understand what are safe NH3 levels All aquariums should have a biological and or chemical filtration to control ammonia Biological filtration uses bacteria colonies to convert ammonia to less harmful substances Chemical filters remove the
|
|
|