|
- Fuel recommendation for 383 sbc | Yellow Bullet Forums
Just got my 383 build done and in the car Have not got to test it yet it currently has ethanol free pump 93 in the tank Looking to see what it might need for octane Its a 383 with ported Profiler 72cc aluminum heads, Probe 8cc dome pistons Cam is a Jones Hyd roller 240-250@ 050
- Spread axle- pros cons - Yellow Bullet Forums
Spread axle will scrub the tires much harder However, they're easier on the tow vehicle, because the axles support the weight over a longer area, which means less porpoising They ride a bit better, as a result of the axles working more independently or less "together" Backing a spread axle is much more difficult, due to the weight distribution being spread so far apart If you encounter
- Blue Print Engines-any good? | Yellow Bullet Forums
Looking for an aluminum headed engine for one of my cars Looking at Summit it appears the Blue Print engines are not to badly priced Anyone have any experiences with them? Thanks Randy
- Whats a good size winch for car trailer? - Yellow Bullet Forums
Hi, I'm looking to buy a winch for my trailer, my car weighs 3000 pounds What would be a good size winch to pull the car up onto the trailer? Im using a 2500 now and it struggles There's a sale on 5000 pound winches and the next size up is 9000 What are you guys using? Thanks!!
- 65 Nova “Patina” Small Tire Build | Yellow Bullet Forums
This is our 65 Nova home built small tire Hot Rod This was a rust bucket we found sitting next to a barn on a farm out in Nebraska We brought her home and fixed every bit of rust, knocked out all the dents and blended in the paint to match the original patina as we found her We bent up the
- Main and Rod bearing prep - Yellow Bullet Forums
Housing bores and the back side of bearing shells can be cleaned with alcohol prior to assembly ACL bearings are manufactured in Australia Clevite is still manufactured in Nebraska, USA but that is in the process of being changed, to Mexico in the very near future
- 68 Camaro rear wheel size | Yellow Bullet Forums
Can anyone tell me what the widest rim tire combo I can get under my 68 Camaro would be I have 15x8's on it now with a 275 drag radial I am planning on building a fab 9 and removing the 12 bolt, still utilizing the factory suspension, but did not want to mini tub unless absolutely necessary
- Trans Fluid for powerglide - Yellow Bullet Forums
I am sure this has already been asked a million times, so sorry if I missed it Can anyone fill me in on what is recommended for the powerglides? Dextron or Type F I plan on using a synthetic due to its ability to handle the heat better but fill me in on type Appreciate it very much Take
|
|
|