|
- Openscape 4000 v10 standby ecoserver cant boot | Tek-Tips
Openscape 4000 v10 standby ecoserver can't boot i tried to make a "replace node" -> the ecoserver screen awlays 0%,the current page returns after 15 mins, i tried many times and the situation is always the same We know that replace node is a network BOOT method initiated by the actived ecoserver in TFTP mode It is through corosync LAN (ETH4)
- Changing MOH on OpenScape Voice | Tek-Tips
From the manual "OpenScape Media Server V9 Administrator Documentation Issue 12": 9 2 10 How to Replace Default Music-on-Hold of OpenScape Voice OpenScape Voice provides default music-on-hold If required, you can replace it with individual music-on-hold On the OpenScape Media Server, the default music-on-hold has names of the format: MOH<x>, with <x> representing a consecutive number between
- OpenStage 40 HFA is unable to boot the application | Tek-Tips
Use the DERT application and reflash the phone DERT uses an older firmware version, but once you get it back to life, you should be able to update the firmware If you don't have DERT, you should be able to find it on TONIDO (See FAQ's) LoPath Maintain HiPath 4000 V5 V6, OpenScape Xpert V4, OpenScape Xpressions, OpenScape Contact Center V8, OpenScape Voice V9
- factory reset Openscape business X5R | Tek-Tips
Dear All, I need to know how to factory reset the Openscape business X5R as I forgot the password and don't know how to login I tried to press the reset button for more than 10 seconds and tried to switch off the device and press the reset button and then power on while keep pressing for more
- Alcatel lucent to Siemens openscape x5 business via sip one way call . . .
Hi guys We have a alcatel lucent as main system connected to Siemens openscape business x5 in other location ,via sip When I make a call from the main
- Openscape 4000 STMIX Flash | Tek-Tips
OpenScape 4000 V10 Volume 4 IP Solutions Service Documentation Issue 39 Check 2 11 1 General Description The STMIX can be re-flashed in case the board is not booting or not becoming READY in RMX
- LTCR Fail in Unify Openscape 4000 V8 | Page 3 | Tek-Tips
Hi, I'm trying to install Unify Openscape 4000 V8, but its LTUCR (previous Version LTUCA) board not getting power there are 2 LED (Red Green) on the
- How to run IPDA on Openscape 4000 | Tek-Tips
Dears, Hi, I ran a clean installation of Openscape 4000 V7 R2 23 3 with no patches, and inserted following commands: exec-dimsu
|
|
|