|
- What is a full strength penetration weld? - Structural engineering . . .
The term "full penetration" (FP) means complete joint penetration (CJP) as opposed to partial joint penetration (PJP) Fig 8-22 In some cases, as pointed out by Jt12, full strength can be achieved without full penetraion IMO, the term "full strength penetration weld" means, a CJP (FP) welded joint that can attain full strength
- pipe penetration on structural members - Eng-Tips
Also, plan for horizontal penetrations to be outside the compression block in sections with heavy flexural stress Horizontal penetrations may interfere with longitudinal reinforcing placement, so look carefully at this DO NOT attempt to relocate prestressing strand to avoid penetrations - move the penetration
- MAX. PENETRATION, MAX. CONTACT FORCE ERROR and NEGATIVE EIGENVALUES . . .
PENETRATION, MAX CONTACT FORCE ERROR and NEGATIVE EIGENVALUES is a problem or i can stay with them? If yes, how can i fix them and how they afect my results Some exemples: "***WARNING: THE SYSTEM MATRIX HAS 23 NEGATIVE EIGENVALUES " "MAX PENETRATION ERROR 2 51836E-09 AT NODE SUPORTEPE-31-1 904 OF CONTACT PAIR (ASSEMBLY_S_SURF-822,ASSEMBLY_M
- Weld penetration details - Boiler and Pressure Vessel engineering
Double sided groove welds made without back gouging are considered to be partial joint penetration groove welds unless the WPS was qualified without back gouging From the sketch, it appears the bevel groove on the bottom side is welded first and then back gouged from the top side
- Roof Penetration detail through Metal Roof 1 - Eng-Tips
Penetration-Free Attachment A first rule about any rooftop mounting is to do it without penetrating the roof membrane whenever possible While this may seem obvious, on metal roofs, it is often violated The norm for attaching things seems to be: "anchor to structure through the roof "
- Butt Weld Penetration Depth - Welding, Bonding Fastener . . . - Eng-Tips
The ability to accomplish a full penetration weld is governed by the welding process, the filler metal, the base metal and the joint type Additional limitations maybe defined by the governing organizations and jurisdictional authorities (AISC, ASME, AWS, ANSI, DOD, etc) You have identified some processes and some base materials
- Complete penetration welds - Structural engineering general . . . - Eng-Tips
For large penetration welds the fabricator would often use double sided with a 60 40 or 70 30 split on weld and remember any plate with a full pen weld uses twice the volume of weld as for a double sided pen weld with the associated shrinkage
- Penetration - ANSYS: ANSYS Software Suite | Eng-Tips
Hello I would like to simulate under ANSYS stretching along an axis of a hollow sphere For that, I modele a sphere and inside I glue two small balls on each side I impose only a displacement along x for balls, one in one direction and the other in the other direction My problem is that the
|
|
|