|
- Core One and MMU3 - Prusa3D Forum
RE: I spoke to a Prusa employee at Formnext about the MMU3 After I showed him my solution without a buffer, he said that a similar system would be used on the Core One He described the current MK4 MMU3 setup as a bit messy and not very space-saving and that a much better solution is being sought for the Core One
- English forum – Prusa3D Forum
Prusa EasyPrint General discussion, announcements and releases Known issues and troubleshooting
- PrusaSlicer – Prusa3D Forum
Latest Post: Prusa Connect Keeps Showing Printer is Offline Our newest member: val Recent Posts Unread Posts Tags Forum Icons: Forum contains no unread posts Forum contains unread posts Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed
- VFA Artifacts on X+Y Straight Edges - Prusa3D Forum
VFA Artifacts on X+Y Straight Edges Hi guys just got my new assembled Core One, I had a Prusa MK4S (as a kit) and it was a great printer, all prints came off great with that one E1njoying the Core One but currently am getting very visible VFAs on all long X+Y prints I did a long print last night in Stealth mode on Structural profile and all the prints had VFAs across basically all axis
- CORE One and soft TPU - Prusa3D Forum
RE: CORE One and soft TPU This sounds consistent with what Prusa recommends for inserting flexible filaments into to XL: Cut the filament to a pointed tip, reduce the idler tension, disconnect the PTFE tube It takes an extra step on the Core One because the top panel has to be removed to gain access, but otherwise it seems the same?
- New stable FW 3. 14. 1 for MK3, MK3S, MK3S+, MK2. 5 and MK2. 5S is out
New stable FW 3 14 1 for MK3, MK3S, MK3S+, MK2 5 and MK2 5S is out Summary Add filament presence check at start of print Region Mesh Bed Levelling fixes Show filament color name during M600 Fix safety timer not handled correctly Delay Z-Axis on Autoload Replace hard coded crash z lift value with Pause Z lift value Send host actions on filament runout Lower MIN_Z_FOR_UNLOAD from 50mm to 20mm
- 6. 3. 2 Firmware for Prusa CORE One - Prusa3D Forum
6 3 2 Firmware for Prusa CORE One Summary Adjusted RPM range check for the Print Fan test This is the stable release of firmware 6 3 2 for the Prusa CORE One, addressing issues with certain print fans Adjusted RPM range check for the Print Fan test The lower threshold of acceptable fan speed during the Print Fan test has been reduced from 5130 rpm to 4800 rpm This change improves
- Prusa CORE One + important links - Prusa3D Forum
RE: Prusa CORE One + important links Hmm, on closer examination, I think a few of the parts may be interchangeable with the Core One, but most unfortunately look quite different
|
|
|