|
- 1800 Brakes: Bleeding Brakes and Clutch, Pad Wear Indicator
2) Reservoir No 2 is the remote brake fluid reservoir, located knee-high, at the right-hand side of the bike, just above the rear brake pedal It is used to flush the lower bleeder valves located on either side of the front-wheel brake calipers and the rear-brake bleeder, located on the rear wheel, at the top of the rear-brake caliper
- Removing 1300 coolant hoses and bypassing heat flow in. . .
Vacuum pump to empty the coolant reservoir Return hose at pump removed, used county water to give it a good rinse After that I rinsed it with "Distilled" water, cranked it briefly I added concentrated prestone yellow jug 2 quarts and one quart distilled water Add fresh coolant in the recovery tank Vacuum pump to get the air bubbles out
- Brake reservoir - Honda VTX Forum
Got a hole in the lower brake fluid reservoir by the rear brake pedal on an '06 VTX 1800 R Anyone know where I can get a replacement I'm in Pa a little south of Harrisburg if that helps any Thanks , riders
- Engine Coolant Change. - Honda VTX Forum
#19 · May 31, 2009 coolant reservoir location fill procedure Coolant reservoir on my 1800 is in front of the back wheel I had to take the voltage regulator off to pull the reservoir out To fill the entire system, I left my gas tank on I put a few small blocks of wood wrapped in washcloths under it to keep it up off the frame about 3 inches
- 1800 Rear Brake Issues - Honda VTX Forum
I know I do not need to bleed my car brakes unless I open the system or the reservoir gets to low and causes air to get in If there is an opening (loose fitting or cracked line), then fluid will leak out When I bled the rear brakes on the bike, the air came from the rear caliper and not from the front
- VTX 1300 coolant replacement - Honda VTX Forum
I just bought my bike and it has 25000 miles on it I do not know if the coolant has ever been replaced So,can I just remove the hose from the bottom of the radiator, let it drain, refill, circulate, remove, drain, etc, then put new coolant into the reservoir? Or do I need to take it to the
- CLUTCH FLUID CHANGE - Honda VTX Forum
Pull the clutch master cap and the side cover on the left rear just above the kickstand Under the chrome side cover you'll see a bleeder Open it until the reservoir is almost empty Close the bleeder and fill the reservoir with Vlavoline Synpower DOT 4 fluid Re-open the bleeder and keep filling the reservoir until fluid comes out clear down below Close the bleeder and make sure fluid level
- Coolant Change - Honda VTX Forum
At my last coolant change I connected a vacuum pump to the hose going to the reservoir and pumped some air out of the system a few times The hoses collapsed some, released and added more coolant Repeated this a few times Added fresh coolant to the reservoir The burp was done with the vacuum pump
|
|
|