- Résidu blanc sortant après le traitement du gaz contre. . .
Salut les amis, Récemment acheté un modèle VTX 1300 C 2003, il a à peine roulé, comme prévu, il y avait de la rouille à l'intérieur du réservoir d'essence Voici les étapes que j'ai suivies, mais maintenant j'ai un résidu blanc qui sort quand je rince l'essence du réservoir Qu'est-ce que c'est
- Removing 1300 coolant hoses and bypassing heat flow in. . .
Vacuum pump to empty the coolant reservoir Return hose at pump removed, used county water to give it a good rinse After that I rinsed it with "Distilled" water, cranked it briefly I added concentrated prestone yellow jug 2 quarts and one quart distilled water Add fresh coolant in the recovery tank Vacuum pump to get the air bubbles out
- Brake reservoir - Honda VTX Forum
Got a hole in the lower brake fluid reservoir by the rear brake pedal on an '06 VTX 1800 R Anyone know where I can get a replacement I'm in Pa a little south of Harrisburg if that helps any Thanks , riders
- 1800 Rear Brake Issues - Honda VTX Forum
I know I do not need to bleed my car brakes unless I open the system or the reservoir gets to low and causes air to get in If there is an opening (loose fitting or cracked line), then fluid will leak out When I bled the rear brakes on the bike, the air came from the rear caliper and not from the front
- 1800 Brakes: Bleeding Brakes and Clutch, Pad Wear Indicator
2) Reservoir No 2 is the remote brake fluid reservoir, located knee-high, at the right-hand side of the bike, just above the rear brake pedal It is used to flush the lower bleeder valves located on either side of the front-wheel brake calipers and the rear-brake bleeder, located on the rear wheel, at the top of the rear-brake caliper
- VTX 1300 coolant replacement - Honda VTX Forum
I just bought my bike and it has 25000 miles on it I do not know if the coolant has ever been replaced So,can I just remove the hose from the bottom of the radiator, let it drain, refill, circulate, remove, drain, etc, then put new coolant into the reservoir? Or do I need to take it to the
- CBR1000RR Clutch Problems: No Pressure! - Honda VTX Forum
Sounds like he only replaced the fluid in the reservoir and didn't bleed the thing all the way through (from the bleeder on the clutch slave, down below) Have him turn the handlebars all the way to the right, so the clutch reservoir is as high and level as possible Carefully remove the cover and drain a small amount of fluid out of the reservoir
- Break Fluid Change - need help suggestions | Honda VTX Forum
Keep an eye on the reservoir level, do not let it drop enough to expose the inlet Once the old is purged, all you need to do is to put the float board back on top of the fluid in the reservoir and add enough fluid to float that board up to the full line; replace the rubber expasion seal and then the cover with screws
|