|
- The Hull Truth - Boating and Fishing Forum - Bait tray for Rtic 65
The powdercoating on mine began peeling off in large sheets in less than a year It apprears they form them, powder coat them and then drill holes leaving exposed edges of metal and the corrosion under the powder coat starts there
- The Hull Truth - Boating and Fishing Forum - Bait tray for RTIC COOLER
Rtic interior width at the top = 11 75" Yeti interior width at the top = 11 75" Both 65s have the lip an
- Boating and Fishing Forum - RTIC Cooler Cushion Seat? - The Hull Truth
Crazybeard I took the chance and ordered the Wise 3rd party seat from amazon for my RTIC 45 and it lines up just fine I haven't actually installed the snaps yet so no pics, but have taken it out of the box and lined it up to check fit You can't tell it wasn't made for the cooler, IMO The filling has just the right support too
- The Hull Truth - Boating and Fishing Forum - RTIC Coolers
Or rtic goes out of business because of the active litigation Your and my deposit money is probably gone The Chinese manufacture is not going to give the money back and if Rtic is banko, we will be unsecured creditors for a few hundred bucks Why do they need a deposit 60 days before the coolers will start to ship?
- The Hull Truth - Boating and Fishing Forum - RTIC Cooler Cushion Seat?
It was only $56 for my RTIC 45 which is about $70 less than it would cost for me to have one made The foam is nice and firm Fit is off just a little bit in my opinion I think it should be about a half to one inch deeper to fit well The seams on the side are a little funny as they bulge out but for the price, I think it's a 5 5
- The Hull Truth - Boating and Fishing Forum - SOLVED Yeti stolen. . . what . . .
Awesome! I updated the first post but the bottom line is that the Rtic 65 does fit If it was any bigger in length it would not clear the leaning post, if it was any bigger in width it would not be able to stow completely on the factory slider and the height is not a factor
- Boating and Fishing Forum - Contender 23 25T - The Hull Truth
I have a RTIC 145 on my 23T Fits over the center fish box hatch perfectly Use the Kennedy system with turnbuckles and you can still open the hatch by pushing up on the cooler Empty, it works well Full, you may need a buddy to help you
- The Hull Truth - Boating and Fishing Forum - Blazer Bay owners
It cruised faster offshore than my Grady 257 I had a Suzuki 300 on the Blazer It’s light weight and tows easily It’s a bit stern heavy so I moved the trolling batteries in forward hatch and kept a 140 quart RTIC up front ( plenty of room) 24 volt Rhodan held it tight in a current and you could fish several days with out recharging
|
|
|