Toyota Handbrake Adjustment - Hoppers Stoppers Custom Brake Upgrades 2: Back off rubber stoppers at rear of brake backing plates so lever can return all the way 3: Adjust drum handbrake so shoes are almost contacting the drum surface If this is over adjusted it can create drive line shudder at speed
Brake issues - Landcruiser Club - Toyota Owners Club - Australia Jack up under the axle un adjust the hand brake cable in cab then back off the hand brake shoes then readjust the shoes so the wheel turn freely then adjust the cable in cabin just enough for it to hold at with about 6 clicks too tight causes shoes to drag
Handbrake Improvement - Land Cruiser Club Before, the handbrake was just an ornament and wouldn't stop the truck creeping in 'Drive' or 'Reverse' on tickover Now its solid, the handbrake is on with the lever half-way up its travel and it will hold the truck and a heavy trailer without any problems
(DIY) How to Adjust Handbrake | IH8MUD. com Forum - IH8MUD Forum On my 2011, I was able to adjust the handbrake as described - thanks for the info! Also, I just changed my rear brake pads and rotors, and the original rotors from factory had a rubber stopper where you'd normally use the flat head screwdriver to adjust eBrake
how to adjust hand brake - Toyota Nation Forum Once the pads are set properly you may need to adjust the cable To do this, you need to remove the centre console Then near the handbrake lever, you should see the cable and 2 nuts at the end of it Undo the top one which is the locknut and adjust as necessary Set it so the lever stops after 5 clicks 1994 Camry Executive A T - Burnt to a crisp